ReadyMadeRC
ALTITUDERC NANO 5.8G FPV TRANSMITTER
Dimensions (w/o antenna and cables) | Width |
Length | 0.80in |
Height | 0.26in |
Weight | 3 gr |
Input voltage range | 3.4v - 12.6v (1s - 3s lipo) |
Camera output voltage | 3.6v |
Output power | 13-14dBm (25mW) |
Power connector | JST female |
Camera connector | JST ZH on the transmitter, loose end wire to camera. |
Frequencies | Switch # |
ReadyMadeRC
5.8 GHZ NANO WINDMILL RHCP OMNI ANTENNA (3 BLADE)
Gain | 0.5-1.3 dbic (Point one lobe forward for good video on the way back) |
ReadyMadeRC
IFTRON - STINGER PRO 5.8GHZ 25MW AV TRANSMITTER
Item Description Our new Lower Power Nano 5.8 transmitters conform with the power requirements of many countries that limit the RF power to 25mw. Features include: on-board switching power for ultra-wide input voltage, plus one line-level audio input- all at a very economical price. Want more power and features? Please see our Mondo Stinger 5.8 or Stinger Pro 8.5 transmitters. Comes with whip antenna Audio cable and one of these Plug & Play Power/video Cables (See picture below) If you already have a camera that uses a 3 pin connector, please check the connector picture for wiring compatibility with your camera. If your camera is opposite of ours, please ask for a "REVERSE" cable when ordering or you will have to reverse it yourself. All Iftron Transmitters are Urethane Conformal Coated for moisture protection. Comes with antenna and input cable. Made in USA Lead Free Wiring and Information Here,
Channel 1 5.740GHz Channel 2 5.760 GHz Channel 3 5.780 ...ReadyMadeRC
ZEISS CINEMIZER HEADTRACKER
http | //www.inreal-tech.com/ |
ReadyMadeRC
FY-901 MULTI-ROTOR FLIGHT STABILIZATION CONTROLLER
mail us | service |
The FY-901 for multi-rotor copter can be used in the following models:, , :, , The FY-901 has been tested to work well with the following RC system:, , The FY-901Operating Mode for multi-rotor copter supports two flight modes :, , 1: Auto-Stabilization mode., : 3D Control Mode., Gyroscope initialization (re-setting):, , Out of the box, the FY-901 has been fully initialized. However, if the following condition occurs, resetting the gyro is recommended:, , NOTE:,
Introduction FY-901 has integrated three-axis gyro and three-axis accelerometer, which ...