HobbyKing
8MM SHAFT MOUNT FOR TOWERPRO & 24G MOTOR
towerpro 240* motors as well ..." />
| Shaft Size | 8mm |
| Weight | 3grams |
5 Reviews
HobbyKing
TOWERPRO MG996R 10KG SERVO 55G / 10KG / .20SEC
towerpro ..." />
: JR (Fits JR and Futaba),
This is essentially an upgraded version of the famous towerpro ...5 Reviews
HobbyKing
TOWERPRO ALLOY STICK MOUNT FOR 24** MOTORS
,
This little low priced device will save you as much ...5 Reviews
HobbyKing
TOWERPRO H-TYPE ESC PROGRAM CARD
TowerPro ..." />
,
Use this card to quickly and easily program your TowerPro ...5 Reviews
HobbyKing
TOWERPRO 9805BB SERVO 160G / 20KG / .20SEC
| Weight | 160g |
| Dimension | 66*30.2*64.4mm |
| Operating voltage | 4.8-7.2V |
| Temperature range | 0~55 Celcius |
| Dead band width | 5us |
Stall torque:, 20kg/cm(4.8V )C25kg/cm(6V), Operating speed:, 0.20sec/60degree(4.8v), 0.16sec/60degree(6v),
The 9805 is a large double bearing servo, often used ...5 Reviews
HobbyKing
TOWERPRO MG946R 12KG 55G / 12KG / .20SEC
: JR (Fits JR and Futaba),
Higher torque version of the MG995. Good for slow trainers, ...5 Reviews
HobbyKing
TOWERPRO W25A BRUSHLESS SPEED CONTROLLER
| Voltage | 3 Cell |
| BEC Current | 1.5A |
| Braking Selection | Soft/Hard |
: 25A (max 33A burst), : 2-3Cell Lipo / 5-12Cell NiMH, : 45x38x10mm, : 24.5g,
Amp rating Battery Size Weight Programmability; BEC on/off MCU Cell ...5 Reviews
HobbyKing
TOWERPRO 9G W12A BRUSHLESS SPEED CONTROLLER
| Rating | 12A Burst, 10A Constant |
| BEC | 1.5Amp |
| Timing | Auto |
| Lipo | 2~3 |
| NiMH | 4~12 |
FET: 6, PWM: 8k,
A great little 12A BESC, very light and very stable. ...5 Reviews
HobbyKing
LIGHT AIRCRAFT 182 W/ ESC, MOTOR AND SERVOS PLUG-AND-FLY DELUXE VERSION
| Weight | 600g w/ battery |
| ESC | 25A brushless |
: 780mm / 30.7in, : 980mm / 38.6in, Prop:, 8x6 (Spare Included), Motor:, Brushless Bell motor, similar to the towerpro 2908-21 (1530kv), Battery:, 11.1v 1300mAh 3S1P (Not included), Battery Compartment:, 110 x 34 x 32mm (MAX), Servos:, 9g x 4 (Quality servos, with precise control.),
182 18A Brushless Deluxe Version This kit will take you ...5 Reviews
HobbyKing
HXT 8MM ALLOY MOTOR MOUNT 2.5G
,
Motor mount. To suit motors with shaft size of 8mm. ...5 Reviews
HobbyKing
HEXTRONIK 24GRAM BRUSHLESS OUTRUNNER 3000KV
towerpro engine mount ..." />
| Load [no prop] | 1.2a / 7.4v @ 21500rpm (0g thrust) |
| Load [7x4 prop] | 21A / 7.4v @ 8800rpm (380g thrust) |
| Load [8x3.8 prop] | 22A / 7.4v @ 8200rpm (430g thrust) |
| https | //www.hobbyking.com/hobbyking/store/comersus_viewItem.asp?idProduct=3613 |
5 Reviews
HobbyKing
HXT 2730 ACCESSORY KIT (MOUNT/PROP SAVER)
,
Motor mount. To suit motors with shaft size of 8mm. ...5 Reviews
HobbyKing
FF SUPER CHIPMUNK ELECTRIC ARF
| Material | Fibreglass & balsar. |
| Wingspan | 998mm |
| Length | 810mm |
| Wing Area | 16dm sq. |
| Height | 210mm |
| Airfoil | NACA2416 |
| Flying Weight | 820g |
| Suggested prop | 7060 or larger |
5 Reviews
HobbyKing
HXT 2730 DIY KIT
| Wire Guage | .44mm |
| https | //www.hobbyking.com/hobbyking/store/comersus_viewItem.asp?idProduct=3613 |
5 Reviews
HobbyKing
HEXTRONIK DT700 BRUSHLESS OUTRUNNER 700KV
| Required Voltage | 11.1v |
| Suggested Battery Capacity | 1300mAh + |
| Suggested Prop | 10x4.7, 11x3.8 or 11x4.7 |
| Max current draw | 13A (with 11x4.7 prop) |
| Max thrust | 900g+ |
| No Load Current | 1.2A |
| Shaft | 4M (perfectly suited to Towerpor/GWS SF Slow Fly props) |
| Weight | 78g |
| Diameter | 41mm |
| Overall length | 77mm |
Kv: 700rpm/v,
Looks can be deceiving. This outrunner is around twice the ...5 Reviews