DPCAV
5.8GHz Micro Receiver, 12V
,
SOLD OUT: No longer available.
This pocket sized 5.8GHz wireless video receiver has dual A/V outputs. Offers high quality video and mono audio. Specifications and Features
Compact 5.8GHz receiver.
8 frequency channels.
-90dBm sensitivity typical.
50 ohm RF port impedance.
RP-SMA RF connector.
NTSC / PAL compatible, standard 1Vp-p video (75Ω).
Line Level Audio (10KΩ).
Dual Audio-Video Output Jacks.
Left/Right mono audio (compatible with stereo amplifiers).
7 - 13 VDC @ 200mA
1.3mm x 3.5mm micro barrel type power Inlet.
JST/BEC power cable.
2.4 x 2.0 x 0.5 inches (61 x 52 x 13 mm).
Only 48 grams (without antenna).
Important: This wireless video receiver is NOT compatible with the Airwave brand 5.8GHz transmitters. You must use the #TX5.8-200mW and other compatible video transmitters.
The receiver operates on a wide voltage range (7-13 VDC) and is compatible with 3S LiPO battery packs. Several power cord options are offered so you can choose what is best for your installation.
For example, custom DiY installations would probably choose the bare plug (requires soldering). The plug is also available with pre-installed leads (one end has bare wires). For convenient mating to a compatible 3S LiPO battery, a plug with a female JST/BEC connector can be chosen. Please note that the prices vary, depending on the selected power cord option.
Important: Never exceed the recommended maximum voltage or reverse the polarity. Otherwise permanent damage will result and the warranty will be void.
The standard antenna is a basic OEM style dipole. An upgraded dipole can be chosen that provides better performance. A photo comparison of the two antenna choices is shown at the bottom of the page. For even longer range an 8dBi patch antenna is available separately: Click me for details.
The RC305 receiver is directly compatible with 5.8GHz rated antennas and coax cables that are equipped with RP-SMA connectors. It can be easily converted for use with the SMA style connector by installing a RP-SMA to SMA adapter (available separately), such as the #SMA-015.
Instructions for Setting Frequency
Frequency selection is set by the receiver's switches as follows:
Switches #1, #2, and #3 Set Frequency.
Note 1: Black area is tip of switch levers.
Note 2: Switch #4 is not used.
CH1= 5.705 GHz CH2= 5.685 GHz CH3= 5.665 GHz CH4= 5.645 GHz CH5= 5.885 GHz CH6= 5.905 GHz CH7= 5.925 GHz CH8= 5.945 GHz
Your purchase includes the receiver, antenna, and one A/V cable. To use the second video output an additional A/V cable must be purchased.
SOLD OUT: No longer available.
Check price and availability
Found 11 years, 9 months ago