Flying-Hobby
3DX500 0.6M 22 "RHINO GEAR" ULTRA HARDENED STEEL PINIONS
,
For pinions as tough as a Rhinoceros! Try our new ...Flying-Hobby
3DX500- 0.6M 24T "RHINO GEAR" ULTRA HARDENED STEEL PINIONS
,
For pinions as tough as a Rhinoceros! Try our new ...Flying-Hobby
EDGE 713MM PREMIUM CF BLADES - FLYBAR VERSION
| - Length | 713mm |
| - Width | 60mm |
| - Root | 12mm |
| - Bolt Hole | 5mm |
Features:, , Specs:, , Includes:,
EDGE high performance CF rotor blades are new premium blades ...Flying-Hobby
FUTABA DIGITAL METAL GEAR SERVO S3156
| Torque(4.8V) | 2.0kg/cm |
| Speed(4.8V) | 0.13sec/60 deg. |
| Torque(6.0V) | 2.4kg/cm |
| Speed(6.0V) | 0.11sec/60 deg. |
| Dimension(mm) | 21.8x11.0x21.9mm |
| Weight(g) | 9.3g |
Flying-Hobby
SAVOX SH-1357 DIGITAL SERVO SET ( 3PCS)
| Stall torque | 1.9kg.cm(4.8V) |
| Motion speed | 0.09sec/60°(4.8V) |
| Rating voltage | DC 4.8-6V |
| Temperature range | -20°C~+60°C |
| Dimension | 35 x 15 x 29.2mm |
| Weight | 25.9g |
Flying-Hobby
FUTABA 4YF 2.4GHZ 4CH TRANSMITTER & R2004GF RECEIVER (MODE 2)
| Power Requirement | 4.8V or 6V shared with servos |
| Current Drain | 30mA at no signal |
| Size | 1.54 x 1.02 x 0.39" (39 x 26 x 10mm) |
| Weight | 0.49oz (14g) |
Standard Functions :, FHSS (Frequency Hopping Spread Spectrum) eliminates frequency pins and signal interference-pushbutton transmitter/receiver linking with no binding plugs, R2004GF Receiver Features:, :, For use with the 4YF-2.4GHz FHSS transmitter, :, Package Content:, 1 x Futaba T4FY 4ch 2.4GHz FHSS Transmitter,
********can not ship to Turkey and Belgium( as the custom ...Flying-Hobby
CAPACITOR PACK (12S MAX, 50.0V, 1100UF)
Helis:, CC CapPack is highly recommended for all 500 class and larger heli applications where Y harnesses and long wires can bleed voltage and hard collective pulls can strain even the most powerful batteries., Cars/Trucks:, With their high torque requirements – going from 0 to 100% throttle isn't easy on controllers or batteries - RC cars and trucks put enormous loads on brushless power systems. Use CC CapPack to help your system power through the abuse., Aircraft:, Larger electric power systems lead to larger electric powered aircraft, and sometimes the distance between the battery pack and the ESC grows beyond the length of the wires installed on the components. Adding wire also adds inductance, which can increase the ripple voltage in a system. CC CapPack essentially negates the ripple caused by the addition of up to 8 inches of length to the battery wires., Note: All Castle controllers with data logging capabilities can report the ripple voltage they encounter during use. Ripple voltage peaks should always be less than 10% of the total pack voltage; the smaller the ripple voltage the better. If an application exhibits more than 10% ripple voltage under peak loads, the user should consider using higher discharge (C Rating) batteries, shorter wires, higher current connectors, better gearing or a smaller load.,
CC CapPack is useful in all brushless motor applications, where ...Flying-Hobby
HOBBYWING PLATINUM 150A PRO ESC
| 1.1 Output | Continuous 150A, burst 220A up to 10 seconds. |
| 1.2 Input Voltage | 2-6 cells lithium battery or 5-18 cells NiMH battery. |
| 1.3 BEC | None. |
| 1.4 Control Signal Transmission | Optical/electrical coupled system. |
| 1.5 Max Speed | 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM. |
| 1.6 Size | 88mm (L) * 55mm (W) * 15mm (H). |
| 1.7 Weight | 125g. |
| 2.3 Three types of start mode | Normal / Soft / Very-Soft, compatible with aircraft and helicopter. |
| 2.5 Multiple protection features | Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection. |
Flying-Hobby
HOBBYWING PLATINUM-70A HV PRO ESC
| 1.1 Output | Continuous 70A, burst 105A up to 10 seconds. |
| 1.2 Input Voltage | 5-12 cells lithium battery or 15-36 cells NiMH battery. |
| 1.3 BEC | None. |
| 1.4 Control Signal Transmission | Optical/electrical coupled system. |
| 1.5 Max Speed | 210000rpm for 2 Poles BLM, 70000rpm for 6 poles BLM, 35000rpm for 12 poles BLM. |
| 1.6 Size | 70mm (L) * 34mm (W) * 16mm (H). |
| 1.7 Weight | 82g. |
| 2.3 Three types of start mode | Normal / Soft / Very-Soft, compatible with aircraft and helicopter. |
| 2.5 Multiple protection features | Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection. |
Flying-Hobby
YS 56SR HELI ENGINE
| Bore | 23.0 mm |
| Stroke | 22.0 mm |
| Displacement | 9.14 cc |
| RPM Range | 2,000-20,000 |
| Weight | 406 grams |
Flying-Hobby
THUNDER TIGER RED LINE RL-53H
| Content | RL-53 engine x 1 EA |
Flying-Hobby
TREX 600/700 N - ALLOY FUEL TANK CAP (BLACK)
,
Product Detail High quality replacement fuel tank stopper suitable for ...Flying-Hobby
EDGE 693MM PREMIUM CF NIGHT BLADES - NITE LITEZ
| Specs | - Length |
| - Width | 60mm |
| - Root | 12mm |
| - Bolt Hole | 5mm |
Features:, - Airfoil designed specifically for flybarless helicopters., Includes:, - One pair of EDGE Nite Litez blades.,
Product description LE-693FBLNL EDGE 693mm Premium CF Blades - Nite ...Flying-Hobby
EDGE 753MM PREMIUM CF BLADES - FLYBARLESS VERSION
| Specs | - Length |
| - Width | 65mm |
| - Root | 14mm |
| - Bolt Hole | 5mm |
| - Weight | 250 +/- 5 Grams |
Features:, - Airfoil designed specifically for flybarless helicopters.,
LE-753FBL EDGE 753mm Premium CF Blades - Flybarless Version EDGE ...Flying-Hobby
EDGE 713MM SE PREMIUM CF BLADES - FLYBARLESS VERSION
| Specifications | Length |
| width | 60mm |
| root | 12mm |
| Bolt Hole | 5mm |
| Weight | 199g/1 |
Features:, - Airfoil designed specifically for flybarless helicopters., Includes:, - One pair of EDGE blades.,
EDGE high performance CF rotor blades are new premium blades ...