HobbyKing
DIGITAL METAL GEAR SERVO 16G/4.6KG/.16SEC
| Model | HD-2213MG |
| Voltage | 4.5v~6v |
| Speed | 0.16sec @ 6.0v |
| Torque | 4.6kg.cm @ 6.0v |
| Bearings | 1BB |
| Gears | Metal |
| Weight | 15.8g |
| Size | 22.8x12x29.4mm |
5 Reviews
HobbyKing
TURNIGY BRUSHLESS ESC 60A W/ REVERSE PROG. (V2.2)
| Cont. Current | 60A |
| Burst Current | 380A |
| Resistance | 0.0007ohm |
| Car Size | 1/10 |
| BEC | 6V/ 1.5A Output |
| Size | 31.5*27.5*24mm |
| Weight | 32g |
Suggested Motor:, Around 5.5T / 3650kv, Battery:, 2-3 Cell Lipo / 4-9 Cell Ni-XX, Motor Type:, Sensorless Brushless,
The Turnigy series are programmable car and boat brushless speed ...5 Reviews
HobbyKing
TURNIGY NANO-TECH 1800MAH 3S 25~50C LIPO PACK
| Capacity | 1800mAh |
| Dimensions | 115x35x21mm |
| Balance Plug | JST-XH |
| Discharge Plug | XT60 |
Voltage:, 3S1P / 3 Cell / 11.1V, Discharge:, 25C Constant / 50C Burst, Weight:, 161g (including wire, plug & case), Suited to the following models:, ALIGN T-REX450, E-flite Blade 450 3D/400 3D, BEAM E4, MSH Protos Mini, Furion 450, ThunderTiger E325/Mini Titan SE, Caliber 450V.,
More than just a fancy name. TURNIGY nano-tech lithium polymer ...5 Reviews
HobbyKing
HK2839 EDF OUTRUNNER 2800KV FOR 70MM
| Specs | Kv- |
| Dimensions | 64 x 28mm |
| Shaft diameter | 4.0mm |
| Shaft length | 15mm |
| Voltage | 14.8V |
| Weight | 95g |
| Output Power | 550w |
| Max Current(<60s) | 36A |
| Thrust | 1200g(42.33oz.) |
| Recommended model weight | 800-1200g |
| Recommended model fans | 70mm Fans |
| Mounting Hole Bolt Circle | 18mm & 20mm |
| Mtg. Hole Number & Size | 4 x M2 |
5 Reviews
HobbyKing
TURNIGY 1800A SERVO 8G/1.7KG/.10SEC
| Model | TGY-1800A |
| Speed | 0.10sec |
| Torque | 1.7kg/cm |
| Size | 22x11.7x24.3mm |
Voltage:6v, Weight:8g,
Micro analog servo. Precise, jitter free response for small parkflyers ...5 Reviews
HobbyKing
TURNIGY K-FORCE 100A BRUSHLESS ESC
| Input Voltage | 2-6 cells lithium battery or 5-18 cells NIMH battery. |
| 2 Pole | 210,000rpm |
| 6 Pole | 70,000rpm |
| 12 Pole | 35,000rpm |
| Weight | 82g. |
| *Multiple protection features | Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection |
Specification:, Output:, Continuous 100A, burst 150A up to 10 seconds., BEC:, Switching mode DC-DC regulator., Control Signal Transmission:, Optically coupled system., Max Speed:, Size:, 70mm (L) * 34mm (W) * 16mm (H)., Features:, *High performance microprocessor (24khz) brings out the best compatibility with all kinds of motors and the highest driving efficiency.,
The Turnigy K-Force series are based on an all new ...5 Reviews
HobbyKing
SINGLE CELL 3.2G / .16KG / .10SEC DIGITAL ULTRA-MICRO SERVO
| Torque | 0.16kg ~ 0.19kg |
| Weight | 3.2g (.11oz) |
| Speed | 0.10 ~ 0.08sec / 60deg |
| Voltage | 3v~4.2v |
| Motor type | Coreless |
| Plug | JST/1.5mm |
5 Reviews
HobbyKing
DIGITAL HIGH TORQUE BEARING SERVO 41G/4.1KG/.17SEC
| Model | HD-4180BB |
| Voltage | 4.5v~6v |
| Speed | .17sec |
| Torque | 4.1kg/cm |
| Bearings | 2BB |
| Gears | Plastic |
| Weight | 41g |
| Size | 41x20x36mm |
5 Reviews
HobbyKing
GWS 8CH DUAL CONV 35MHZ FM RECEIVER
| Model | GWRXS001 |
| Channels | 8ch |
| System | FM (PPM) Dual Conversion |
| Voltage | 4.8~7.2v |
| Current Drain | 10mA |
| Weight | 22g/.78Oz |
| Size | 65x25x15.5mm |
| Range | 600mtr+ / 2000ft |
| Adjacent channel rejection | better than 65dB at ± 10k Hz |
| Image rejection | better than 65dB |
| Spurious rejection | better than 80dB |
| nter modulation | better than 65dB |
Sensitivity : 1,
GWS 8ch Dual Conv 35mhz FM Receiver The compact, lightweight ...5 Reviews
HobbyKing
POLYQUEST 2550MAH 4S 25C LIPOLY (VERSION 2)
| Capacity | 2550mAh |
| Cell Model | PF 7138110XP |
| Voltage | 14.8V |
| Charge Current(2C) | 5.0A |
| Continous Dis.(25C) | 62.5A |
| Dimension(mm) | 136 * 38 * 27 |
| Weight | 256g |
| http | //www.enerland.com |
| http | //www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=8790 |
5 Reviews
HobbyKing
SCM 3213 1750KV BRUSHLESS OUTRUNNER
| Battery | 2-3 Lipoly |
| Max Eff | 81% |
| Max Current | 7 to 11A (over 74% efficiency) |
| Int. Resistance | 89mohm |
| 10v no Load current | .75A |
| Dimensions | 25.7 x 26mm |
| Shaft | 3mm |
| Weight | 45g |
| Model Size | up to 300-630g |
| Recommended Prop | 9x5 3S / 10x5 2S |
Kv: 1750rpm/v,
Spec.3 Reviews
HobbyKing
D-MG16 METAL GEAR 2.9KG/.08SEC/18.8G
| Model | D-MG16 |
| Weight | 18.8g |
| Torque | 2.9kg @6v |
| Speed | .08sec |
| Voltage | 4.8 to 6v |
| Size | 29 x 11.2 x 29mm |
| Gear | Metal |
5 Reviews
HobbyKing
TURNIGY MG958 COMPOSITE DIGITAL METAL GEAR SERVO 15KG / 65G / 0.2SEC
| Operating voltage | 4.8V |
| Operating temperature range | -20~+60C |
| Motor type | Coreless motor |
| Potentiometer drive | Indirect drive |
| Bearing type | Dual ball bearing |
| Gear type | All metal gears |
| Connector wire length | 12in |
| Weight | 2.24oz. (65g) |
Control system:, +pulse width control 1520usec neutral, Required pulse:, 3-5V peak to peak square wave, Operating speed:, 0.2sec / 60 degree at no load, Stall torque @ 4.8V:, 166 oz/in. (12.0kg.cm), Stall torque @ 6.0V:, 200 oz/in. (15.0kg.cm), Operating angle:, 45 deg. one side pulse travelling 400usec, Direction:, Counter clockwise/pulse travelling 1520-1900usec, Dimensions:, 40.2 x 20.1 x 36.8mm,
Turnigy MG958 Composite Digital Metal Gear Servo 15kg / 65g ...5 Reviews
HobbyKing
GWS NARO+D 10G DIGITAL SERVO
| Model | Naro+D |
| Voltage | 4.8v~6.0v |
| Speed | .16sec |
| Torque | 1.6kg/cm |
| Weight | 10g |
| Size | 22.2x11.0x24.95mm |
5 Reviews
HobbyKing
CONTRA ROTATING BL SYSTEM 375W
| Dimension | 28mm x 51mm |
| Diameter of shaft | 3.0mm |
| Length of front shaft | F10.25mm |
| Max power | 375W |
| 11V 10.5A*2 Thrust | 1320g/46.56oz |
| ESC Required | Two 25A |
| Note | The motor comes with plastic prop now instead of wood, Photo will be updated very soon. |
Weight:, 79g / 2.83oz (not including connectors), : 17A*2=34A, : 1050rpm/v, :10*4 or 10*5,
Max power KV Prop *Includes props, as shown in the ...5 Reviews