Thunder Power Flying-Hobby Page 19 Review

Flying-Hobby

HYPERION G3 CX 0130 MAH 1S 3.7V 25C/45C SINGLE CELL W/UM CONNECT (EFLITE ULTRA MICRO)

These are a major upgrade for Eflite Ultra Micro and ...

Flying-Hobby

IN-FLIGHT VOLTAGE LOGGER & HEALTH ANALYZER

Working temperature	-20 C-50 C
Weight	10g
Size	53x 29x 5mm
MAX *** The maximal voltage. The display of the highest cell voltage of the battery. Picture 2	MAX U3

Introduction:, With 6 months development, improvement and test, the new battery voltage logger and health analyzer has been released to the market. The R1 is not only an accurate 6S battery voltage cell meter, but also integrated with battery health analysis function. So it's really a necessity to the model pilots., Specification:, , Feature:, Small, light and ultra-portable with only 5mm thickness, including LCD screen., Remarks and attentions:, -Due to the battery pack loading drop, to avoid the voltage measurement difference error, make sure the battery pack is disconnected at least 30 seconds., How to Use:, , 1. Normal battery voltage check:, Connect the battery to the R1 after the battery is unloaded for at least 30 seconds. To connect the battery balance plug to the R1, always use the pin 1 on the R1, and make sure the negative pin of the battery balance plug is connected to the R1 pin 1. For example: if a 3S Li-Po pack need to be measured, connect the battery to R1 1~4 pin, and the negative pin on the balance plug is connected to pin 1; If a 5S battery pack, then connect the battery to pin 1~6, and the negative balance plug still to pin 1. Now you can read voltage value on the display., 2. Lowest voltage recording:, The lowest voltage recoding function is designed for the purpose of logging the lowest voltage value when the battery is loaded during the flight, then it's possible for the pilots to understand how their battery works., Activate the function:, [A]. Connect with the battery, after the R1 is initialized, press ¡§A¡¨ button till the ¡§hold¡¨ appears on the bottom-right on the screen, which means the lowest voltage capturing (LVC) mode is enabled., Connect the R1 with battery, and enter health analysis function. Then it indicates the following:, M,

User's manual Voltage value and capacity display. Up to 6 ...