ngHobbies
500MW LM 2.4GHZ TRANSMITTER
Please note: This product will not be sold/shipped to USA customers. Your order of the product will be cancelled and your payment refunded., Features:, Frequency Band:, 2400MHz, Number of Channels:, 8, Audio Sub-carrier:, 6.5MHz, Transmission Range:, 200-500 Meter, Power Consumption:, 450mA, Output Power:, 500mW, Operation Voltage:, 5-5.5V, Power Supply:, 5V/500mA, Antenna Connector:, SMA Connector, Weight:, 10 g, Dimensions:, 24 x 28 x 7 mm, Documentation:, , Warranty:, 6 months, Note:, The use and operation of this product in most states will require a HAM or Amateur radio license., Important note for Canada customers:, Please note, channels 4,5,6,7 and 8 of this transmitter are outside of the allowed frequency spectrum for Canada. These channels cannot be legally used even if you have a Radio Amateur license. Please make sure that you obey Industry Canada regulations around use of these devices and use them only on channels 1, 2 and 3. New Generation Hobbies cannot be held responsible for using these transmitters on channels which are outside of the legal allowed frequency ranges.,
Highly integrated mini 2.4 GHz transmitter with well known quality ...ngHobbies
ARDUPILOT MEGA MINIMOSD REV. 1.1
| Dimensions | 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H |
| NOTE | This product is not compatible with the APM 2.0. |
It features two independent power and ground sections to isolate the OSD's analog stage:, a +5V section for the ATmega and the OSD's digital stage, powered through the FTDI cable or other +5V source; and a regulated +5V section for the OSD's analog stage, powered through the video in/out header and capable of handling up to +12V input. Solder jumpers are available to combine the two power and ground sections if desired., Set up instructions:, click here to download or open,
MinimOSD, a minimal Arduino-based on-screen display board. It's tailored for ...ngHobbies
NGH V680AC
| There are different charging modes for all requirements | Charging-Auto/Balance, Fast charging cycle, Charging for storage, Cyclic charging, etc. |
Features:, Input Voltage range:, DC: 11V-18V, AC: 110/240V, Charging current range:, 0.1A - 6A, Charge power limit:, Max. 80W, Discharge power limit:, 10W, Balancing current:, max 300mA, NiCd/NiMH cell count:, 1-18cells, Lithium battery types:, Li-Po, Li-Ion, Li-Fe, Lithium battery cell count:, 1-6 cell, Pb battery voltage:, 2-24V, Weight:, 640g, Dimensions:, 145x145x56mm, Model Memory:, 5, Ports:, DC input, Balancing Port, Output port, Temperature sensor, USB,
The V680AC is a low cost high preformance Li-Po, Li-Ion, ...ngHobbies
500MW LM 1.2GHZ TRANSMITTER
Please note: This product will not be sold/shipped to USA customers. Your order of the product will be cancelled and your payment refunded., Features:, Frequency Band:, 1200MHz, Number of Channels:, 6, Audio Sub-carrier:, 5.5MHz, Transmission Range:, 200-500 Meter, Power Consumption:, 450mA, Output Power:, 500mW, Operation Voltage:, 5-5.5V, Power Supply:, 5V/500mA, Antenna Connector:, SMA Connector, Weight:, 10 g, Dimensions:, 24 x 28 x 7 mm, Documentation:, , Warranty:, 6 months, Note:, The use and operation of this product will require a HAM or Amateur radio license., Important note for Canada customers:,
Highly integrated mini 1.2 GHz transmitter with well known quality ...ngHobbies
REMZIBI OSD PACKAGE
| - Supply power requirement | 7V-14V (ie |
| - Weight | 16 gram (OSD + dedicated GPS) |
Technical Data:, Functionality:, - PC connection for configuration/calibration purposes using dedicated PC program, Button function:, - Save home position (short click), Information currently available on the OSD (additional hardware may be required):, - Latitude (format DDMM.MMMM or DD.DDDDDD can be choosen), Documentation:, English Documentation, Software:, Click here, Support forum:, Click here,
Remzibi's OSD is an On-Screen-Display unit that is used along ...ngHobbies
IPOWERUS 9V LIPO RECHARGABLE BATTERY
| Li-Polymer 9V (8.4V) 500mAh, min. 470mAh, (Hi-Rate mode | min. 415mAh). |
| Length (mm) | 26.5±0.2 |
| Width (mm) | 17.5±0.2 |
| Height (mm) | 48.5±0.5 |
| Weight(g) | Approx 27.5g |
| Nominal Voltage(V) | 8.4V |
| Discharge Cut-off Voltage | 6.4V |
Specifications:, Note:, This battery CANNOT be charged with any other 9V chargers! Please ONLY use the, The 500mW power should keep the 500mW Ngh-Txm-633 video transmitter running for minimum of 30 minutes (we tested for the lenght of 40-42 minutes with a new battery), but please remember:, Safety First!!!,
High rate discharge mode with over (2.0C5) for 30 min ...ngHobbies
900MHZ 12 CH DIGITAL DISPLAY RECEIVER
Features:, Frequency Band:, 900MHz - 1300Mhz, Number of Channels:, 12, Channels:, 0:910 MHz, 1:980 MHz, 2:1010 MHz, 3:1040 MHz, 4:1080 MHz, 5:1120 MHz,, 6:1160 MHz, 7:1200 MHz, 8:1240 MHz, 9:1280 MHz, A:1320 MHz, B:1360 MHz, Video Output:, 75 Ohm, RCA, Power Consumption:, 250mA, Audio Output:, 10k Ohm, RCA, Power Supply:, 12V/500mA, Antenna Connector:, SMA Connector, Weight:, 140 g, Dimensions:, 115 x 80 x 21 mm, Warranty:, 3 months, Note:, Please note this receiver comes without a power supply.,
Highly integrated 12 channel digital display receiver, to be used ...ngHobbies
1200MW 5.8GHZ COMBO
| Receiver sensitivity | -90dBm |
| Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860 and 5880MHz |
| Weight | 70 grams |
| Size | 72 x 43.5 x 11mm |
| Input voltage | 6 – 18V at 200 mA (2 or 3s Lipo Ideal) |
| Operating Frequencies | 5720, 5740, 5760, 5780, 5800, 5820, 5840, 5860, 5880MHz |
| Weight | 67 grams |
| Size | 70 x 36 x 18mm |
| Input voltage range | 8-14V |
The package contains:, 1 x Highly integrated mini 5.8GHz 1200 mW transmitter with cooling fan, so it can be installed in closed spaces as well., Receiver:, A/V receiver with one antenna input, Transmitter:, 1200mW output power, Documentation:, N/A, use the connection diagram in the photo below for connection clarification., Power Plug:, Middle pin positive, Manufacturer warranty:, 3 months from the date of purchase,
This is a combo deal for a plug and play ...ngHobbies
12 CH DIGITAL DISPLAY RECEIVER
Features:, Frequency Band:, 900MHz - 1300Mhz, Number of Channels:, 12, Channels:, 0:910 MHz, 1:980 MHz, 2:1010 MHz, 3:1040 MHz, 4:1080 MHz, 5:1120 MHz,, 6:1160 MHz, 7:1200 MHz, 8:1240 MHz, 9:1280 MHz, A:1320 MHz, B:1360 MHz, Video Output:, 75 Ohm, RCA, Power Consumption:, 250mA, Audio Output:, 10k Ohm, RCA, Power Supply:, 12V/500mA, Antenna Connector:, SMA Connector, Weight:, 140 g, Dimensions:, 115 x 80 x 21 mm, Warranty:, 3 months, Note:, Please note this receiver comes without a power supply.,
Highly integrated 12 channel digital display receiver. Compact size. Manual ...ngHobbies
100MW 5.8GHZ FATSHARK TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 20 grams |
| Size | 57 x 34mm |
| Input voltage range | 6 - 16 v |
Parameters:, 100mW output power, Content of the package:, 1 x 100mW Transmitter module, Note:, The use and operation of this product in most states, countries may require a HAM or Amateur radio license. New Generation Hobbies cannot be held responsible for your actions if you use this product without proper licensing.,
The Fatshark 5.8Ghz 100mW transmitter is a state of art ...ngHobbies
12V CAMERA HARNESS FOR IMMERSIONRC TRANSMITTERS
Instructions:, Step 1:, Solder the 5 pin cable which came with your ImmersionRC transmitter on your camera: black wire to black wire, red wire to red wire, yellow wire to yellow wire. The green and the white from the connector can be isolated, these are audio wires unless you use a microphone you do not need them. Use a heat shrink to secure the connections., Step2:, Plug the camera cable prepared in step one into the harness. You will need to plug the 2 male connectors of this harness into your InnersionRC or Fatshark tranmsitter, 2 pin connector to the power connection, 5 pin connecto to the A/V connector., Step3:, Plug the 3S (3 cell) LiPo battery into the JST connetor of the harness., Warning:, Do not ever use this harness with 5V cameras. Also make sure you never use more tha 3 cell LiPo's to supply power to this harness. The voltage from the battery is directly fed to the camera, if you use more than 3 cell LiPo you will smoke your camera right away.,
This FPV cable harness offers connection for 12V cameras to ...ngHobbies
25MW 5.8GHZ IMMERSIONRC TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 20 grams |
| Size | 57 x 34mm |
| Input voltage range | 6 - 16 v |
Parameters:, 25mW output power, Content of the package:, 1 x 25mW Transmitter module, Note:, The use and operation of this product in Canada and United States will require a HAM or Amateur radio license. Please check with your local authorities before purchasing this product.,
The Immersion RC's 5.8Ghz 25mW transmitter is a state of ...ngHobbies
CONNECTOR CABLE SET IMMERSION RC
Audio/Video Pigtail:, Black - Ground -, Power Connector Pigtail:, Black - Ground -,
This is a replacement cable set for the Immerion RC ...ngHobbies
SPEKTRUM SATELLITE DIVERSITY CONTROLLER
| Connector 1 | Connection to the flight controller |
| Connector 2-5 | Connection to satellite receivers |
Binding Instructions:, As any spektrum receiver, the diversity board and the satellite receivers connected to it will have to be bound to your spektrum transmitter. To enter the binding mode, you will need to hold the binding button pressed while powering on the circuit. All attached satellite recievers will be blinking fast during binding mode. The LED on the diversity receiver board will blink briefly 3-6 times, then it will turn off for a few seconds after which it will start flashing again - waiting for the RC signal. At this point follow the instructions of your RC transmitter to turn it on in binding mode. When the RC binding signal is detected, the satellite receivers will follow their routine of binding and blink slower. When the binding is complete, the LED's on the satellite recievers will stay on and on the diversity board will turn off., The package contains:, 1 x MK Diversity Controller, Documentation:, Additional documentation translated by google:, Click here,
This litte diversity controller has been designed to connect 4 ...ngHobbies
2 CH DIGITAL DISPLAY RECEIVER 1.3GHZ
Features:, Frequency Band:, 1300Mhz, Number of Channels:, 2, Channels:, 1:1258 MHz, 2:1280 MHz, Video Output:, 75 Ohm, RCA, Power Consumption:, 250mA, Audio Output:, 10k Ohm, RCA, Power Supply:, 12V/500mA, Antenna Connector:, SMA Connector, Weight:, 140 g, Dimensions:, 115 x 80 x 21 mm, Warranty:, 3 months, Note:, Please note this receiver comes without a power supply.,
Highly integrated 2 channel digital display receiver. Compact size. Manual ...