RCPlanet
FUTABA CR-2000 DC PEAK CHARGER FUTCR2000
, Length:, 6" (152mm), Width:, 3.4" (86mm), Height:, 1.4" (36mm), Weight:, 355g (12.5oz), Battery Range:, Tx: 6-8 cells, 500-2000mAh, Battery Range:, Rx: 4-6 cells, 50-2000mAh, Glow Plugs:, 1 cell, 2000-3000mAh, Input Voltage:, DC11V-16V, Operation Voltage:, 10.5V, Charging Current:, Tx 0.5A-2A, Charging Current:, Rx 0.05-2A, Cut Off:, Delta Peak, Trickle charge rate:, at .05 to .45A rate is 5 mils, Trickle charge rate:, at .5 to 2.5A rate is 70 mils, Power Supply:, 7.2V NiMH Battery, Current Drain:, 300mAh, Note:, For use with NiCDs or NiMH batteries only. TX and RX can be charged simultaneously. Don't short-circuit or reverse connect battery. Avoid places where the charger will be exposed to direct sunlight. Perform charging within the 41-104F°(5-40C°) temperature range. Do not charge radio batteries and glow starter simultaneously., ,
Features peak charge detection with auto cut-off with audio alert. ...SDSHobby
4.8-9.6V 230V CHARGER (FUTABA/JR)
| Input | AC 220-240 50Hz |
| Output | Transmitter 9.6V DC100mA |
| Receiver | 4.8-6V DC 100mA SUIT FOR Ni-cd battery |
Specification:,
SDSHobby
KDS N590 DIGITAL TAIL SERVO 2.5KG/25G WITH 25T FUTABA GEAR FOR KDS450 HELICOPTER
| Speed | 0.08sec/ 60 degree at 4.8V, 0.07sec/ 60 degree at 6.0V; |
| Torque | 2.0kg/cm at 4.8V, 2.5kg/cm at 6.0V; |
| Output shaft gear qty | 25T FUTBA |
| Operating frequency (Hz) | 300 |
| Dimension | 35.5mm x 15mm x 28.6mm |
| Weight | 25g |
| Application | could be used as tail servo for KDS450 Helicopter or other branded 450 series helicopters |
Introduction:, , Specification:,
The servos are high performance digital servo. They come with ...SDSHobby
LOST MODEL ALARM FINDER TRACER FOR HELICOPTER AIRPLANE (COMPATIBLE WITH FUTABA/JR)
| Style | Radio Control Toy |
| Place of Origin | Guangdong China (Mainland) |
| Model Number | 0100A |
| Type | Airplane |
| Radio Control Style | RC Model |
| Material | electric |
| Power | Battery or Gas |
| Volume | Big voice |
| Weight | 4.7g only |
| Operating Voltage | 4-6 volts DC |
| Current consumption | < 35 mA (1 mA at standby mode) |
| Alert Level | 85dB ( like jet-plane engines sound) |
| Installation | Share signal channel from any Servo unit |
Brand Name: ST, Specification:, With this device, you can easily locate and find your lost plane/helicopter ,The, Instructions:, Connect the alarm between the servo and the receiver, i.e. act as a servo,
effective range for this tracer is over 50 meters.Simply turn ...SDSHobby
OUTPUT L350MM/18AWG MULTI-CHARGING CABLE SET WITH T PLUG, BANANA CONNECTOR, CROCODILE CONNECTOR, FUTABA CONNECTOR, JST CONNECTOR, TAMIYA CONNECTOR AND SIX PIN CONNECTOR
Specifications for Silicone Cable:, Cable Length:, 350mm, Cable Type:, 18AWG, Cores of Copper Wire:, 150 Cores,
SDSHobby
ORIGINAL FUTABA S3003 STANDARD SERVO 4.1KG/37G W/NYLON GEARS FOR RC CARS AND BOATS
Specifications:, , No Load Running Speed:, , Stall Torque:, , Size:, , Weight:, , Connector:, , Gears:, , Application Fields:, , Included Parts:, , Kindly Remark:,
0.23 sec/60° at 4.8V, 0.19 sec/60° at 6V 3.2 kg-cm ...SDSHobby
FUTABA S3001 4.1KG/45G STANDARD ANALOG SERVO WITH BALL BEARINGS
Specifications:, No Loading Speed:, 0.28sec/60 degrees at 4.8V ;, Stall Torque:, .4kg.cm at 4.8V ;, Dimensions:, 40.5×20×36.1mm, Weight:, 45.1g, Interface Type:, JR, Bearing Type:, Ball Bearing, Gear Type:, All Nylon Gears, Connector Wire Length:, 305mm, Current Drain (4.8V):, 7.2mA/idle, Current Drain (6.0V):, 8mA/idle, Operating Voltage:, 4.8-6.0 Volts, Operating Temperature Range:, -20 to +60 Degree C, Operating Angle:, 45 Deg. one side pulse traveling 400usec, Features:,
0.22sec/60 degrees at 6.0V 3kg/cm at 6.0V This is a ...