FrSky Tx and Rx Systems Page 3 Review

HiModel

FRSKY 2.4G 6-CHANNEL TWO WAY COMMUNICATION RECEIVER D6FR

Compatible with FrSky two way telemetry modules	DFT, DJT, DHT, DHT-U
Dimension	422211mm
Weight	7.1g
Operating Voltage Range	4.0V-10.0V
Operating Current	50mA
Specified Range	1.5km
Resolution	3072 (>11bit)
Frame Rate	18ms (FS)
Please kindly follow the steps below to perform range check	(Note

, , , , , , Specifications:, , , , , , , , , , , 1.1 Compatibility:, 1.2 Specification:, 9ms (HS), Setup, 2.1 Bind procedure:, 1) Turn your transmitter on and switch it to PPM mode (if not set). Turn your transmitter off., 2)Turn your transmitter on while holding the F/S button on the transmitter module (Please make sure that both switches on the transmitter module are OFF in two way mode) Release it in a few seconds. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the receiver., 3) Connect battery to the receiver while holding the F/S button on the receiver. The LED on the receiver will flash, indicating the binding process is completed., 4) Turn on the transmitter and connect battery to the receiver. The Green LED on the receiver will indicate the receiver is receiving commands from the transmitter., 2.2 Range check:, It is highly suggested to perform pre-flight range check. Caution must be paid when you perform range check in environment with metal fences, concrete buildings, or rows of trees. Loss of signal may be experienced from reflections., 1) Place the model at least two feet (60cm) above non-metal contaminated ground (like wooden bench)., 2) Place the receiver’s antennas apart. Do not let the antennas touch the ground., 3) Place the antenna of the transmitter in a vertical position., 4) Turn on the transmitter and receiver, press the F/S button of the transmitter for 4 seconds to enter range check mode, the RED LED of the transmitter module will be off, GREEN LED will flash rapidly, the BEEPER will sound. The effective distance will be decreased to 1/30 of full range., 5) Walk away from the model whi,

Features: Features: 1) Lighter in weight and smaller in dimension. ...

HiModel

FRSKY 2.4G 8-CHANNEL TWO WAY COMMUNICATION RECEIVER D8R-XP

Compatible with FrSky two way telemetry modules	DFT, DJT, DHT, DHT-U
Dimension	552514mm
Weight	12.4g
Operating Voltage Range	3.5V-10.0V
Operating Current	100mA
Operating Range	full range (>1.5km)
Servo Frame Rate	18ms (FS – Normal Speed Mode)

, , , , , , Specifications:, , , , , , , , , , , 1.1 Compatibility, 1.2 Specifications, 9ms (HS – High Speed Mode), , ,

Features: Features 1) Two external analog telemetry ports (A1&A2) and ...

HiModel

BATTERY VOLTAGE SENSOR FOR FRSKY TWO-WAY TELEMETRY SYSTEM

, , , , , , Specifications:, , , , , , , , , , , Battery Voltage Sensor for FrSky Two-way Telemetry System, , ,

Includes/Requires: Includes: 1 x Battery Voltage Sensor

HiModel

90 DEGREE ANTENNA ADAPTER FOR FRSKY 2.4G RF MODULE

, , , , , , Specifications:, , , , , , , , , , , 90 Degree Antenna Adapter for FRSky 2.4G RF Module, , ,

Includes/Requires: Includes: 1 x 90 Degree Antenna Adapter

HiModel

FRSKY 2.4G 4-CHANNEL FASST COMPATIBLE RECEIVER TFR4-B

Operating Voltage Range	3.5V~10V
Operating Temperature Range	-10℃~80℃
Dimension	42177mm
Weight	4.6g
FASST 2.4G	Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode) (including 3PK, 4PK)
FrSky TF Modules	TF-8M, TF-14M

, , , , , , Specifications:, , , , , , , , , , , Number of Channels: 4, Compatibility:, Bind procedure:, 1) Ascertain that the transmitter is in the PPM mode. Turn the transmitter off., 2) Turn on the transmitter while holding the F/S button on the transmitter module. Release the button. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the receiver., 3) Connect the provided binding cable to corresponding channels of VD5M (see 1.1 Compatibility chart for details), and connect battery to the receiver. LED on the receiver will flash, indicating the binding process is completed. Turn off both the transmitter and receiver, and disconnect the binding cable from VD5M., 4) Turn on the transmitter and connect the battery to the receiver. The RED LED on the receiver will indicate the receiver is receiving commands from the transmitter., The receiver/transmitter module binding will not have to be repeated, unless one of the two is replaced., Note: Make sure corresponding channels are connected by provided binding cable when working with the transmitter module., , ,

Features: Features 1) Compatible with FASST 2.4G: Air Systems (7CH ...

HiModel

FRSKY WIRELESS TRAINER CABLE FOR FUTABA TRANSMITTER WTC/1

, , , , , , Specifications:, , , , , , , , , , , FrSky Wireless Trainer Cable for Futaba Transmitter WTC/1, , ,

Features: This is the wireless trainer cable for TFRSP receiver ...

HiModel

REPLACEMENT PLASTIC CASE FOR FRSKY RECEIVER TFR8

Size	54 x 30.3 x 15mm
Weight	7.2g / 0.25oz

, , , , , , Specifications:, , , , , , , , , , , Replacement Plastic Case for Frsky Receiver TFR8, , ,

Includes/Requires: Includes:1 x receiver case

2 Reviews

HiModel

FRSKY LCD DISPLAY FLD-02 (UPGRADING VERSION FOR FLD-01)

Model	FLD-02
Compatibility	FrSky DFT, DJT and DHT
Dimension	554012mm
Pixel	128*64

, , , , , , Specifications:, , , , , , , , , , , Compatibility:, Installation:, Connect FrSky LCD-fdd_lite to the four pins on FrSky telemetry module (Rxd, Txd, +5V, GND) by the provided cable. Confirm the orientation is correct and make sure both switches on telemetry module are OFF., , ,

Features: Features 1) Show all connected sensors data; 2) Capable ...

HiModel

250MM LONG 2.4G RECEIVER ANTENNA FOR FRSKY SERIES RECEIVERS(2PCS)

Length	40cm

, , , , , , Specifications:, , , , , , , , , , , 2.4G Receiver Antenna for Frsky Series Receivers, Also suit for other 2.4G receivers using same length antennas., , ,

Includes/Requires: Includes:2 x antennas

HiModel

400MM LONG 2.4G RECEIVER ANTENNA FOR FRSKY SERIES RECEIVERS(2PCS)

Length	40cm

, , , , , , Specifications:, , , , , , , , , , , 2.4G Receiver Antenna for Frsky Series Receivers, Also suit for other 2.4G receivers using same length antennas., , ,

Includes/Requires: Includes:2 x antennas

HiModel

600MM LONG 2.4G RECEIVER ANTENNA FOR FRSKY SERIES RECEIVERS(2PCS)

Length	60cm

, , , , , , Specifications:, , , , , , , , , , , 2.4G Receiver Antenna for Frsky Series Receivers, Also suit for other 2.4G receivers using same length antennas., , ,

Includes/Requires: Includes:2 x antennas