ReadyMadeRC
RMRC 2100MAH 3S 3C LIFE TRANSMITTER PACK (FUTABA/JR) PICKUP ONLY
Capacity | 2100mAh |
Type | 3S1P / 9.9v / 3Cell |
Constant Discharge | 20C (42A) |
Peak Discharge (2 sec burst) | 40C (84A) |
Pack Size | 100 x 30 x 30mm |
Charge Plug | JST-XH |
Power Connector | Futaba Male |
Watt Hours | 23.31 |
Note:, We recommed a charge rating of 1C (2.5A) or less for this pack. Always remove battery from transmitter before charging., Pack Weight:, 5.6 oz (161g) including wires/connector,
THESE BATTERIES ARE NOT AVAILABLE FOR SHIPPING. STORE PICKUP ONLY. ...ReadyMadeRC
RMRC 2500MAH 3S 3C LIPO TRANSMITTER PACK (FUTABA/JR)
Capacity | 2500mAh |
Constant Discharge | 3C (7.5A) |
Peak Discharge (2 sec burst) | 8C (20A) |
Pack Size | 100 x 30 x 25mm |
Charge Plug | JST-XH |
Power Connector | Futaba Male |
Note:, We recommed a charge rating of 1C (2.5A) or less for this pack. Always remove battery from transmitter before charging., Type:, 3S1P / 11.1v / 3Cell, Pack Weight:, 5.3 oz (150g) including wires/connector,
Have the confidence and piece of mind that your transmitter ...ReadyMadeRC
FUTABA SQUARE ADAPTER FOR AEROSIM FLIGHT SIMULATOR
Futaba mini-square trainer adapter to connect to the USB cable ..." />
,
Futaba mini-square trainer adapter to connect to the USB cable ...ReadyMadeRC
FUTABA DIN ADAPTER FOR AEROSIM FLIGHT SIMULATOR
Futaba DIN style trainer adapter to connect to the USB ..." />
,
Futaba DIN style trainer adapter to connect to the USB ...ReadyMadeRC
PHOENIX FUTABA SQUARE MICRO ADAPTER
Futaba transmitters to Phoenix Flight Sim." />
,
Adapter for most Futaba transmitters to Phoenix Flight Sim.ReadyMadeRC
FRSKY - DFT TELEMETRY MODULE (FUTABA AND HITEC TYPE)
***Note | Not compatible with the L9R rx |
SPECIFICATION:, Operating Voltage Range,
6.0V-13.0V Operating Current 50mA Output Power 60mWReadyMadeRC
FRSKY - DHT-U MODULE TRAINER CONNECTION FOR FUTABA
,
FrSky Upgrade Cable for DFT/DJT/DHT/8ch Telemetry Receiver/Sensor Hub/FLD-02ReadyMadeRC
AEROSIM RC FLIGHT SIMULATOR
http | //vimeo.com/11409098 |
http | //www.youtube.com/watch?v=lMVr1nE58WU |
http | //www.youtube.com/watch?v=g110XcnWwFY |
There are two Training Programs | (1) Airplane, and (2) Helicopter/Multicopter. |
The USB interface is fitted with a 3.5 mono jack that can be directly used with JR/Spektrum/HitecAurora/Turnigy/GraupnerMX. An adapter is required for other transmiters (sold separately), consisting on a short cable with a female 3.5 mono jack on on one end, and the right type of connector for the particular transmitter on the other end. Available connectors include: Futaba Square Plug, DIN6 for Futaba Round Plug and Hitec, Multiplex (DIN5, compatible with DIN7 and DIN8), Graupner with Trainer Socket (jack 3.5mm stereo), and ESky/WFly/Storm (minDIN4)., Please, watch these simulated FPV videos:, FPV flight:, This is the video created by Holger, showing the performance of the MK models in the simulator:, Here is the MK promotional video:,
Description This high quality RC flight simulator includes a CD ...ReadyMadeRC
3DR PIXHAWK
Weight | 38g (1.31oz) |
Width | 50mm (1.96") |
Thickness | 15.5mm (.613") |
Length | 81.5mm (3.21") |
Note:, Pixhawk is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most modern RC receivers (and all those sold by 3D Robotics) allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not. If your receiver does not support PPM output, please add a PPM encoder board option to your order below., Pixhawk includes:, , Options:, , Microprocessor:, , Sensors:, , Interfaces:, , Power System:, , Weight and Dimensions:, ,
Pixhawk is an advanced autopilot system designed by the PX4 ...ReadyMadeRC
STROBON XL POLICE STROBE (RED/BLUE) WITH WIRES
Weight | 3.3g without cable |
Dimentions | 51x18x7mm |
Screw Hole Dimentions | 3mm holes with 43mm space |
Working Voltage | 5-6v (we are suggesting 3A UBEC and 2S lipo for supply) |
Current Consumption | 5mA(idle)/80mA(average when working) |
Wire Length | 30cm standard servo cable with Futaba servo plug |
Features:, ,
New generation STROBON with remote controllable powerful RED - BLUE ...ReadyMadeRC
STROBON XL NAVIGATION STROBE (RED) WITH WIRES
Weight | 3.3g without cable |
Dimentions | 51x18x7mm |
Screw Hole Dimentions | 3mm holes with 43mm space |
Working Voltage | 5-6v (we are suggesting 3A UBEC and 2S lipo for supply) |
Current Consumption | 5mA(idle)/80mA(average when working) |
Wire Length | 30cm standard servo cable with Futaba style servo plug |
Features:, ,
New generation STROBON with remote controllable solid RED light and ...ReadyMadeRC
STROBON XL NAVIGATION STROBE (GREEN) WITH WIRES
Weight | 3.3g without cable |
Dimentions | 51x18x7mm |
Screw Hole Dimentions | 3mm holes with 43mm space |
Working Voltage | 5-6v (we are suggesting 3A UBEC and 2S lipo for supply) |
Current Consumption | 5mA(idle)/80mA(average when working) |
Wire Length | 30cm standard servo cable with Futaba style servo plug |
Features:, ,
New generation STROBON with remote controllable solid RED light and ...ReadyMadeRC
STROBON XL NAVIGATION STROBE (BLUE) WITH WIRES
Weight | 3.3g without cable |
Dimentions | 51x18x7mm |
Screw Hole Dimentions | 3mm holes with 43mm space |
Working Voltage | 5-6v (we are suggesting 3A UBEC and 2S lipo for supply) |
Current Consumption | 5mA(idle)/80mA(average when working) |
Wire Length | 30cm standard servo cable with Futaba style servo plug |
Features:, ,
New generation STROBON with remote controllable solid RED light and ...ReadyMadeRC
EZUHF COMBO STARTER PACKAGE - LITE
http | //fpvlab.com/forums/showthread....rade-procedure |
http | //www.youtube.com/watch?v=gk46N8RKd2c&feature=channel_video_title |
Includes:, , Video describing how to connect to a JR radio if you want to make your own cable:, Notice: The use and operation of this product in the USA and many other countries requires an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. ReadyMadeRC cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.,
This combo gets you all you need to have a ...