HiModel
1-6S Li-Poly Balance Charger RC-Power BC6
| ●Charing rate | 0.1 to 5.0A; discharge rate |
| ●Battery memory | 10 models; USB PC Link |
, , , , , , Specifications:, , , , , , , , , , , ●Li-ion/Polymer/LiFe battery 1-6 sereis, ●Ni-Mh/Ni-Cd battery 1-15 cells, ●lead acide (Pb) 2-20V, ●Charge/discharge cycle 1-5, , ,
Features:
Microprocessor controlled high-performance rapid charger/discharger for NiCd/NiMH/Li-poly/Pb batteries with cell voltage balancer.
●Voltage balancer for Li-polymer battery
BC has an individual-cell-voltage balancer inside. So it does not need any balancer separately when charging Li-poly battery for cell balancing.
●Maximum safety
Delta-peak sensitivity: The automatic charge termination program works on the principle of the Delta-peak voltage detection.
Capacity limit: The charging capacity always calculated b multiple of the charging current and time. If the charging capacity exceeds the limit the process will be terminated automatically when you set the maximum value.
Processing time: you can also restrain the maximum process time to prevent from any possible defect.
Input power monitor: To protect the car battery using as input power from being damaged the voltage of it always monitored. If it drops below the lower limit the process will be ended automatically.
●High-power and high-performance circuit
BC employs the circuit that has maximum output power of 50W. As a result it can charge or discharge up to 15 cells of NiCd/NiMh and 6 series of Li-poly batteries with maximum current of 5.0A.
Includes/Requires:
Includes:1 x BC6 charger
1 x USB cable
1 x temperature sensor
1 x DC clamp
1 x multifunctional extension wire
1 x Igniter plug
1 x JST plug
1 x DuPont plug for receiver
1 x English manual (currently the manual is for type 601BC)
1 x CD disk
Requires:
10-18V 5A DC power source
Check price and availability
Found 11 years, 8 months ago