SDSHobby
FVT LCD Program Box/ Program Card for Brushless Car ESC
| Dimension | 80x60x18mm |
| Weight | 65g |
| Input Voltage | 4.5V |
| Interface Type | Mini USB, one Futaba connector for ESC, Futaba connector for power |
| Power Supply | DC 4.5V~6V |
| Note 3 | Please |
| USB | connect to PC |
Features:, 1. Can setup the parameters of brushless ESC via the button of LCD program box, Parameters:, l, Connecting Instruction:, 1. Switch off the power of ESC, Note 1:, DO NOT turn step 2 and step 3 upside down, Note 2:, Extra power 4.8-6V will need if the ESC hasn’t BEC. Pay attention the polarity and do not connect wrongly., : first pull BEC flat cable into program card, second connect the program card with 4.8-6V power, and finally connect ESC to main power., Button Instruction:, 1, ITEM:, circularly switch over the program items; exit to the self-defined program item setup; entrance to program item setup, VALUE:, circularly switch over the program item values and self-defined program item, OK:, Save and send the value to ESC; confirm the programmable item, Batt:, power supply port for program card, ESC:, connect with programming port on ESC via programming cable,
. Can update ESC program and setup the parameters by connecting the ESC with PC via USB port
l
l
—
6.0V (Extra battery pack will need for program card if the ESC hasn’t BEC)
l
l
. Pull out the control line of ESC from receiver and connect with side port of LCD program card
3. Connect ESC to main power
4. Wait for several seconds, if there is no display, and then check whether the BEC flat cable is connected wrongly or not. Please repeat step 1 to step 3 if you connected wrongly. If you connect right, the first setting item will show on the screen.
, otherwise the program card will not work normally.
strictly do as the following steps
.
.
3
.
Load Default
4
.
5.
6.
7.
Check price and availability
Found 10 years, 8 months ago