Three in one UBEC/CDI switch for Gasoline Engine

Discountinued

SDSHobby

Three in one UBEC/CDI switch for Gasoline Engine

CDI in	6-13V
CDI out	5.2V/0
Weight	15g
Volume	35mm

Technical parameters:, Product features:, How to set the voltage in 4.8V or 6V:, The default detect voltage is 4.8V while leave the factory. If the receiver uses 4 ni-mh batteries, please choose 4.8V voltage for detecting. If the receiver uses 5 ni-mh batteries, please choose 6V voltage for detecting, If you want to change the voltage detect value, please do as follows:, 1. Turn off the receiver’s power., Attentions:,

-5A

(L)*
17mm
((W)*
8mm
(H )

Integrated CDI remote flameout switch, making flying safer

Independent CDI power supply socket. Receiver power completely separates with the CDI power, so you should not worry about that CDI arouses high frequency signal will interfere the receiver
-3S lithium or the A123 directly to the battery power supply can be used directly

UBEC / CDI function, simply CDI output shorted cap pull out the can when the UBEC

using switch channel of the remote control to control the CDI (usually use the fifth channel)

Pair of brown led display the receiver’s supply voltage, (4.8V or 6V can be set free) it can effectively to avoid receiving power shortage in the control.

The unique low voltage police maintain order, when the working electricity is large, and the voltage is for less than 4. 2V or 5V (being survey in 6V) with 3 seconds, the red led light will sharp all the times until the user changes the battery or the battery in charge.

Connect the sign wire to the receiver.

Turn on the receiver’s power.

The red led light flashes rapidly (means on 4.8V voltage detecting), the green led light flashes rapidly (means on 6V voltage detecting).
. Use tweezers or electricity metal to short circuit the red led line and the green led line.

3. Turn on the receiver’s power.

4. Wait for 2 seconds.

5. Set free the tweezers or electricity metal.

(When you do all this, the voltage is set. You can turn on the power after turn off the power to test if it is ok. If not, please redo the steps above.)

voltage light’s status

the green light on

the green light flash

the red light on

the red light flash

voltage detect in 5V

voltage above 4.8V

4.4V-4.8V

4.2V-4.4V

voltage less than 4.2V

voltage detect in 6V

voltage above 6V