RCModelScout.

Hobby-Lobby

60A Pro Switch-Mode BEC Brushless ESC

60A Pro Switch-Mode BEC Brushless ESC Highlights:, Up to 60 amp continuous current with proper air flow, 75 amp peak, 60A Pro Switch-Mode BEC Brushless ESC Specs:, Continuous Maximum Current:, 60A with reasonable cooling, Input Connector Types:, 13AWG with E-flite EC3 connector, Output Connector Types:, 13AWG with 3.5mm Female Gold Bullet Connectors, Cells w/BEC:, 3-6S LiPo or 9-18 NiMH/NiCd,

Advanced programming, allows you to operate up to 7 analog or 6 digital servos
When performance matters in your high-current applications look no further than the E-flite® 60-Amp Pro Switch Mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated Switch-Mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 60 amps continuous current when using 3 to 6 series LiPo battery packs. You can drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic endcaps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range, and more, the E-flite 60A Pro Switch Mode ESC is truly a 'pro series' electronic speed control.

5-volt Switch-Mode BEC circuit capable of 2.5-amp continuous current on any recommended input voltage

Drives up to 7 analog or 6 digital standard-sized servos, with the BEC on any recommended input voltage

3-6S LiPo, 9 to 18 cell NiCd/NiMH input voltage

Finned heat sinks

Programmable motor braking

Safe power arm mode prevents accidental starts

Programmable low voltage cutoff with settings for 3 cell LiPo (9V), 4 cell LiPo (12V), 5 cell LiPo (15V), 6 cell LiPo (18V), or 70% of battery starting voltage

Programmable soft start for helis and airplanes

Auto motor shut down if signal is lost or there is interference

Programmable timing 5 user selectable ranges for use with a larger variety of brushless motors

Programmable throttle input range (1.1-1.9 ms or 1.2-1.8 ms)

Utilizes new smaller MOSFETs technology to minimize weight

Radio System Power On/Off Switch

Optional RS232 Serial Link available for programming

Pre-wired connectors-E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads

Found 11 years, 9 months ago