RCTimer
RCT ECS 6A Brushless Motor Speed Controller
| compliant with Ni-Mh battery | Yes |
| Size | 25mm (L) * 13mm (W) * 4mm (H). |
| Secure galvanization Function | Once electrified, the motor won |
| Lost remote controlled signal protection | When the signal transmitted between emitter and receiver is bad or instable, the aero |
| Overload protection | Power supply will be immediately cut off when an instant high-current appears at starting. You can |
| Halted run protection | If propeller is locked, the max power output is limited at 39%. |
| Lost signal protection | 1 beep per second |
| High temperature protection | 3 beeps per second |
| Power and battery protection | 1 beep per 2 seconds. |
| Warning sound | When rocker is not in the the minimum threshold point,1 beep per second. |
1.Specification:, Continuous current:7A, Pepersistent current:9A, Compliant with Lithium Battery: 2, Weight: 6g, protection: Power supply will be cut off gradually when the electric quantity on singular battery is found less than 3.1V,,
2. Functions & Features
Achieve positive rotation and rollback through regulating motor wires.
Advanced heuristic algorithm applied to meet the requirements for motors with different number of magnetic poles.
’
t be started immediately no matter where the throttle rocker on
remote controller is put.
model may be out of control. The protection program will be started after 4 seconds, and make the motor slow down. If signal
recovered in the 4 seconds, it will work in previous condition.
Cooling down can be achieved by limiting the power when it
’
s reaching
105
℃
.If cooling down failed, the power supply will
be cut off gradually. Now, you have to wait the temperature dropping back to normal and galvanize again to have the normal
service.
Battery
When power quantity is recovered, turn off the throttle and resume it to have normal service again.
galvanize again to resume the normal service.
3.Instruction-Throttle settings
Follow the next guide to deploy the max and min settings of throttle, when you first use or change emitter/ receiver.
The following steps tell you how to make the max and min throttle settings
Put the throttle on the highest position, galvanization, keeping it for10 seconds, a long beep comes to record the max throttle
settings.
Put the throttle on the lowest position, keeping it for 3 seconds, a long beep comes to record the min throttle settings.
Seriate beeps come to indicate normal operations are available.
4.Install
5.Errormessage
Check price and availability
Found 11 years, 9 months ago