HiModel
FPV 5.8G 400mW A/V Transmitter Module (TX) ｜SMA, jack
| Transmitting unit weight | 35g (excluding antenna) |
| video format supported | NTSC/PAL |
| Working frequency | 5645-5945Mhz |
| Power input | 7-15V (3S Lipo suggested, does NOT support 4S Lipo) |
| Transmitting current | 220mA |
| Dimension | 55*26*17mm (excluding antenna) |
| Antenna connection | SMA jack (TX module side) |
, , , , , , Specifications:, , , , , , , , , , , FPV 5.8G 400mW A/V Transmitter Module (TX), Refer to here for connector type diagram, * This product shares the PCB board with the 1000mW version, you may see letters "TX51W-power...." on the PCB board, this is not a mistake. There is no cooling fan on the 400mW version which is a obvious difference., *Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty., , ,
Features:
FPV 5.8G 400mW A/V Transmitting module, a good choice for avoiding interference for customers using 2.4G radio system.
- dimension and weight is similar to 200mw TX, yet the range is extended.
- compare to the 500mw version which with cooling fan installed, the 400mw version is lighter, and consuming less power (longer in-air time), also eliminated vibration to video transmitting system caused by cooling fan.
The 400mw version is a well balanced solution among weight, dimension, range, power consumption etc.
Includes/Requires:
Includes:
1 x transmitting unit (TX)
1 x TX antenna (2db)
* No instruction manual supplied with this product.
Requires:
1 x receiving unit (RX)
Check price and availability
Found 11 years, 8 months ago