RCModelScout.

BevRC

Frsky LCD display

1.1 Specifications:, 1.2 Features:, 1) Show all connected sensors data;, 2. Installation:, Connect FrSky FLD-02 to the UART and power connection on FrSky telemetry module (Rxd, Txd, +5V, GND) by the provided cable. Confirm the orientation is correct and make sure both switches on the telemetry module are OFF, 3 Screen structures:, 3.1 Main Screen, Note: Make sure the battery voltage division ratios are programmed in accordance with those of connected battery voltage sensors., :, , Note: Screen-3 shows up only when FrSky Lipo Voltage Sensor (FLVS-01) is connected, otherwise Screen-4 will show up after Screen-2.,

Product Show

FLD-02

Category：Accessories

1.Introduction

2) Capable of programming alarm thresholds and directions;
3) Firmware upgradable
.

.

FrSky Logo
Version Number
Data Screen
Menu Screen
FrSky Website

3.2 Menu Screen

Temperature (Celsius or Fahrenheit)
Altitude (M/Foot)

The alarm thresholds and directions (either above or below threshold) can be programmed. After alarm thresholds and directions are programmed, click “OK”. ”√” means these values have been remembered by the module.

Below are FrSky default values for RSSI, users can change according to their requirements

Alarm

Than

Value

RSSI

1

＜

45

2

＜

42

3.3 Data Screen

3.3.1. Screen-1

GMT (H/M/S)
Fuel Level
A1 & A2 Voltage
Temperature 1 & 2
Rx RSSI & Tx RSSI

3.3.2 Screen-2

Altitude
RPM
Speed
Rate
Ampere

3.3.3 Screen-3

Total Voltage
Voltage for each cell

3.3.4 Screen-4

Acceleration X/Y/Z
Longitude & Latitude

Found 11 years, 9 months ago