ReadyMadeRC
Hornet OSD with GPS
| For FY-21AP | Fixed Altitude flying mode; for FY-3ZT/FY-31AP |
| GPS speed (Unit | km/h) |
| Current latitude and longitude of the plane (Format | “dddmm.mmm” ) |
| The angle of turning to the return point (Unit | deg) |
| Total flight time (Format | “mm.ss”) |
| Course angle of flight (Unit | deg) |
| (Unit | mA / h) |
| Climb rate (Unit | m/s) |
The telemetry data is as below:, , Relative altitude (Unit : m), Operating temperature(Unit: ℃), Distance to take-off Point (Unit : m), The battery voltage of the video transmitter (Unit: V), Power battery voltage (Unit: V), Power battery current (Unit: A), The OSD can be controlled to show different display information via one spare channel of your radio Rx. There are 5 optional display modes controlled by the different PWM signals. You can use default mode if you do not want to change the display modes.(the 5 modes separately are as following: A. All Information Displayed; B., The modes are shown as below:, , Includes:,
Brief Introduction
The Hornet- OSD overlays flight telemetry information onto your video image. The telemetry information displayed includes flight altitude, flight speed, flight direction, and home direction and so on. You also can save the telemetry information to a MICRO SD card (
available separately
), then realizing trace playback via FYGCS. The Hornet-OSD can be connected to the FY-21AP, FY-31APand FY-3ZT systems (sold separately) to display autopilot telemetric data. Firmware can be updated with the
optional data cable
for future feature changes and updates.
Hornet-OSD automatically adapts to either PAL or NTSC video input and confirms if there is a MICRO SD card or not. The adaptive processes are within about 20 seconds.
Once the input video is detected even if there is interruption to the video signal, the telemetry data of the Hornet- OSD will continue to be transmitted via the video stream.
Application
Hornet-OSD can directly connect to the data output port of FY-21AP, FY-31AP or FY-3ZT, or separately connect to the output port of GPS module, and then overlay the flight data information to the video signal. The application figure is shown as below.
(
Note
：The modules in the imaginary line frame means that you can choose any one of these modules to connect )
Introduction for the flight State of FY-21AP / FY-31AP / FY-3ZT
Name
Introduction
RC
Manual Flight. Autopilot deactivated.
ABM
Auto balance mode
FAF
RTL
Auto Return Mode
ACM
Auto Circle Mode
Interface introduction
1
Attitude measurement error coefficient（refer to the prompt）
11
2
12
Horizon position display
3
13
4
14
5
Flight mode
15
6
16
7
17
The battery power consumed
8
18
‘
Radar’ aircraft Position relative to ‘Radar’ Home position
9
The quantity of satellite used for positioning
19
‘Radar’ Home position
10
Display Modes Selection
Partial Display with Artificial Horizon; C.
Radar Positioning Function; D.Brief Mode; E.Remove All Information)
Latest manual and software avaialble
HERE
.
Hornet OSD Video Overlay Module
FYGPS (10Hz) Module
FYCS100 Current Sensor
Related Wiring
Check price and availability
Found 11 years, 2 months ago