RCPlanet
HPI K5.9 Engine HPI15250
, Displacement:, .36 cu in (5.9cc), Carburetor Settings, High Speed Needle:, Flush with groove, Low Speed and Mid Range Needle:, Flush with carb body, Idle Adjustment Screw:, Set after high speed needle is adjusted-set high enough to keep engine running smoothly but not engage the clutch or turn the wheels. Refer to manual for more detailed carburetor setting info, Height from Crankcase Bottom to top of Cylinder Head:, 4.4" (112mm), Height/bottom of Mounting Tab to top of Cylinder Head:, 3.8" (97.5mm), Distance between Mounting Hole Centers Same Side:, 0.87" (22mm), Distance between Mounting Hole Centers Opposite Side:, 1.5" (38mm), Length from Starter to end of Crankshaft:, 4.4" (112mm), Length from Starter to Front Bearing:, 3.3" (83mm), Width at Mounting Tabs:, 1.8" (45mm), Diameter of Cooling Head:, 2.4" (60mm), ,
HPI Racing K5.9 Big Block Engine with pull starter. Fits all versions of the current glow powered HPI Savage. ABC piston and liner construction, "A"luminum piston with "B"rass cylinder liner that is "C"hrome plated. Three needle composite bodied slide valve carburetor with 9.5mm diameter inlet. Twelve fin aluminum heat sink cylinder head, gun metal gray in color. Two year warranty, valid for engines sold and used in the USA, Canada and South America. Strap In The Power! Get Your Savage Or Savage X Up To Ludicrous Speed With The Monster Nitro Star K5.9 Engine! With Nearly 4hp On Tap And Ground-tearing Amounts Of Torque, There Will Be Nothing You Won't Be Able To Climb Through With This Engine Installed!
Displacement: .36 cu in (5.9cc)
Carburetor Settings-
High Speed Needle: Flush with groove
Low Speed and Mid Range Needle: Flush with carb body
Idle Adjustment Screw: Set after high speed needle is adjusted-set high enough to keep engine running smoothly but not engage the clutch or turn the wheels
Refer to manual for more detailed carburetor setting info
Height from Crankcase Bottom to top of Cylinder Head: 4.4" (112mm) Height/bottom of Mounting Tab to top of Cylinder Head: 3.8" (97.5mm) Distance between Mounting Hole Centers Same Side: 0.87" (22mm)
Distance between Mounting Hole Centers Opposite Side: 1.5" (38mm)
Length from Starter to end of Crankshaft: 4.4" (112mm)
Length from Starter to Front Bearing: 3.3" (83mm)
Width at Mounting Tabs: 1.8" (45mm)
Diameter of Cooling Head: 2.4" (60mm)
Requires: Fuel: Car blend with 20-25% nitro content and glow plug wrench and track equipment
Check price and availability
Found 11 years, 8 months ago