RCModelScout.

Hobby-Lobby

Beli-Zell Glue, 14.5g Tube

,

Beli-Zell Glue, 14.5g Tube BELI-ZELL is suitable for use with almost any material, as well as traditional and modern material
Identical and different materials with each other
The joint surfaces of the assembly parts can vary from rough to plane
Open porous materials (as foams, expanded polystyrene, wood) up to closed porous materials (as metals, glass fibre / carbon fibre laminates) will be bonded safely
Layers of fabrics can be used to make sandwich materials or to reinforced constructions, e.g. a foam - fabric - balsa sandwich or wings planked with balsa / obeche and glass- or carbon fabric as reinforcement.
A lot of materials, which commonly need primers, will be bonded reliable in most cases, however a pilot test is recommended in such cases
Cured BELI-ZELL is completely waterproofed

BELI-ZELL fills cracks and small gaps between the assembly parts, without additional fillers. Thus the joint surfaces need not to beclose-fitting. Gaps are very common with broken foams parts. BELI-ZELL contains no solvents or diamine or fillers
Small amounts go a long way - the adhesive expands 3 to 4 times of its original volume. 14.5 gram BELI-ZELL equals about 35 gram balsa cement. The bonding joint can be easily reworked and sanded after curing. No additional kicker accelerators necessary (e.g. with super glues). BELI-ZELL is applicable in a wide temperature range
Service temperature between -104°C up to 176°C, short time 212°C
The bonding joint does not soften at high temperatures (as with 5-minute epoxy adhesives)
Reliable bonding joint even at a high temperature drift (e.g. model boats)

Very light adhesive, average density 0,25 - 0,33g/cm3 (epoxy adhesives without fillers about 1,3 - 2,0g/cm3)
The bonding joint remains flexible, which is preferable with elastic material like foams. No glass hard or brittle spots, which occur regularly when using super glues or epoxy adhesives. When bonding hard material, like metal only a little amount of BELI-ZELL is needed. This thin film bonding results in a stiff joint between the assembly parts. Even if the same spots needs to be repaired repeatedly, the quality of the bonding joint does not decline unlike super glues or 5-minute epoxy adhesives. Good value since only a small amount of BELI-ZELL is need and BELI-ZELL is a light adhesive (compared to super glues and epoxy adhesives) - 14.5 gram of BELI-ZELL bond a lot more than it appears at first sight. Cured BELI-ZELL shows a fine pored surface, which is a good spare for missing or broken parts - especially for models made of foam. No mixing necessary hence no mixing errors. Precision applicator makes the application of BELI-ZELL easy and prevents wrong dosing. Setting time: Fast - cured within 4-8 minutes (when using BELI-ZELL Kicker), for rapid repair / bonding, fixation and as full substitute for 5-min epoxy glues. 10 minutes for ambitious modellers and maximum adhesive strength. 60 minutes for planking wings, large parts or when time for accurate alignment is essential.

Found 11 years, 9 months ago