ReadyMadeRC
Camera Pan and Tilt Kit
Manual | Pan/Tilt Module |
Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., Comes with a mounting plate that will fit many popular FPV cameras including:, , Note: Currently the back plates are designed for the pan/tilt system being installed on top of the aircraft. If you plan on mounting the assembly inverted under the aircraft, some modifications to the back plate may be required., This kit includes:, , Note: for the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for the servo options listed below. Any other servo must be aligned properly for proper gear engagement., You'll need to supply:, ,
This is a stand alone pan/tilt FPV module that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below).
The modules are supplied with standard 9g servos by default. For better resistance to crash damage, and for better tolerance of 900MHz video systems, HS-65HB servos are available as an upgrade option below.
The module can be attached to the plane of your choice with four screws.
Dimensions listed below in the pictures.
RMRC-420, RMRC-420XV, RMRC-520, RMRC-LL600, RMRC-700XV, and others
.
Additional back plates may be purchased
here
to fit RMRC-480, RMRC-540, RMRC-600XV
, and others.
If you need to mount a camera not listed, please send me a message via the "Contact Us" link to the left.
Laser cut components and required hardware for pan/tilt module.
Two 9g Servos
Double sided servo tape to retain camera and tilt servo.
Pull-ties to hold TX against tape and for holding your wiring down.
Medium CA
5 minute epoxy
Check price and availability
Found 11 years, 9 months ago