RCModelScout.

R2Hobbies

Corona 2.4Ghz 3 Channel DSSS CT3F Radio Gear Module (for Futaba 3PK, Hitec Optic6)

Number of channels:,

Corona 2.4Ghz 3 Channel DSSS CT3F Radio Gear Module (for Futaba 3PK, Hitec Optic6 )
Model Number : rcps21216
This module is ideal for you if you want to upgrade your radio, especially your 3 channel wheel radio to 2.4Ghz. This module is compatible with Futaba, Hitec, WFLY adn Robbe radios (details as below).
An extra receiver could cost you more than $100 if you go for original Futaba 2.4Gz receiver. However, buying this kit not only upgrade your radio to 2.4Ghz but also could use quality extra receiver at low price! The range of this module is more than 2100m in the real ground test. Qaulity is guaranteed.
This Corona 2.4GHz transmitter module and receiver are designed to completely eliminate radio interference and glitches which have troubled model hobbyists for years. The software designed exclusively for the transmitting module and receiver instantly locates and assigns safe and protected channels. Other flyers in the area can not create interference that normally would corrupt transmitter signals. The Corona 2.4GHz adheres strictly to Frequency-Hopping Spread Spectrum (DSSS) communication standards by constantly switching across a wide band of frequencies. Combining Corona’s software with DSSS we have designed a transmitter and receiver capable of providing modelers the highest performing radio system available.
Features:
Extended operating range 1.5 km range, which has been tested in a real flying environment.
A 3dbi gain transmitting antenna ensures the wave lengths are evenly distributed throughout the transmitting horizon ensuring the stable signal.
One-key user friendly setup mode.
Perfect receiver antennas guarantee the plane receives the signal regardless of the maneuver or attitude.
The unique receiver design makes the Corona module easy to install and ensures reliability.
Corona's advanced needle design ensures the lightest possible receiver
Futaba : 3PM, 3PK, 7U, 8U, 8J, 9C, 9Z and FN series.
Hitec : Optic6, Eclipse7
WFLY : WFT09, WFT08
Robbe : C18, C28
Compatible Receiver :
Corona CR2D, CR3D, CR4D, CR6D, CR8D
Operating Voltage Range :
6V10V13vRely on the transmitter
Operating Current :
100mA
Resolution :
10bit
Weight (without Antenna):
~27g
1-3
Latency :
22ms
Sensitivity :
100dbm
Channel :
3
Case :
Shrink wrap
Receiver Dimension :
41.2 * 21 * 8.1mm
Receiver Weight :
~7.5g (with shrink wrap)
Gross Weight :
132g
Items included:
Corona 2.4Ghz DSSS CT3F Transmitter Module
Corona 2.4Ghz CR3D Receiver
Antenna

Found 11 years, 9 months ago