RCPlanet
Hot Bodies Lightning Stadium 2 PRO RTR HBS66861
, Vehicle, Length:, 22.9" (582mm), Width:, 16.4" (416mm), Height:, 6.25" (159mm), Weight:, 7.2 lbs (3275g) approx, Wheelbase:, 14.5" (369mm) wheels on-center front-to-rear, Front and Rear Tread:, 14" (356mm), Front and Rear Track:, 16.1" (410mm), Ground Clearance:, 2" (51mm), Gear Ratio:, 3.6 :1, Body, Length:, 18.1" (460mm), Width:, 7.1" (181mm), Height:, 5.1" (130mm), ,
This is the 1/8 scale Hot Bodies Lightning Stadium 2 PRO RTR with a Red Painted Body.
Features:
Aluminum 0.12" (3mm) thick purple anodized chassis
Four wheel, shaft driven
HPI TF-1 27MHz AM radio with high torque steering servo, steering and throttle trim and reverse, dual rate steering, transmitter does not have charge jack
HPI .28 cu in (4.6cc) Power House big block engine with electric starter
Tuned pipe exhaust with header
Plastic fuel tank with flip top cap, splash guard and overflow drain 5.1 oz (150cc)
Three shoe clutch, 13 tooth metal clutch bell and purple aluminum flywheel
Single-speed transmission
Rubber sealed ball bearings, used throughout except servo saver where bushings are used
Four aluminum bodied shocks, oil filled with coil-over springs, plastic shock spacers, and 3.5mm hardened shock shafts
7075 (T6) 4mm thick front and rear shock towers (purple anodized)
Metal main gear, 46 tooth
Sealed front and rear gearbox
Bevel gear (hardened) differentials
Dual disk brake on the front and single disk on the rear
Tires are knobby tread rubber with foam inserts pre-glued to wheels ,1.6" (41mm) wide, 3" (76mm) inner diameter, 4.75" (121mm) outer diameter
White dish plastic wheels 1.6" (41mm) wide, 3" (76mm) diameter
Painted polycarbonate plastic buggy body with nylon rear racing wing
Black plastic partial front bumper
Front and rear sway bars
Adjustable caster/toe-in
Adjustable front and rear camber
Bell-crank type steering with two steering link mounts for Ackerman adjustability
Servo Saver included
22 degree hub carriers
Front CVA axles and rear dog bones
Center CVA shafts (front and rear)
Machined aluminum front and rear braces (purple anodized)
Includes:
One 1/8 scale Hot Bodies Lightning Stadium 2 PRO RTR with oil-filled aluminum bodied shocks, painted body with wing, air filter, 46 tooth main gear, tuned pipe, manifold with spring, fuel tubing, engine, radio system, setup DVD, decal sheet, 4 way wrench, 13 tooth clutch bell, and an illustrated instruction manual
Requires:
7.2V stick 6-cell with Tamiya type connector
12AA Batteries
Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant.
Check price and availability
Found 11 years, 8 months ago