SDSHobby
1/8 18CXP Nitro off-Road Truck RTR with 2.4G Radio, Four-wheel Drive
| Length | 490 mm |
| Width | 380 mm |
| Height | 225 mm |
| Wheelbase | 310 mm |
| Tread (F/R) | 380 mm |
| Wheel Diameter | 156 x 86 mm |
| Gear Rate | H16.5 |
| Weight | 3.55 kg |
| Engine | 18CXP |
| Radio Control System | 2.4G |
| Remote control system | 2.4G Radio |
Technical Parameters:, Feature:, Oil-dampened suspension travel, Start The Engine:, 1. The process of cleaning before driving your car for cleaning the engine,1-2 tank oil's use is a standard, and then run your car slowly to run out of another 1-2 tank oil, all ways down, the cleaning work is over, the car can run normally;, . Turning on the transmitter and the receiver: extend the antenna of the transmitter and the receiver, and then switch on the transmitter and the receiver in succession; while switching on the receiver, make sure the carburetor is at the neutral position., 3. Fill the fuel:, Fill the special model's fuel, and mix the gas and the lubricating oil, the rate of the gas to the lubricating oil is 25:1;, 4. Starting the engine:, push the front valve several times until securely streaming out oil;, 5. Stop the engine:, The engine will immediately stop running as long as you press the stall switch of the engine, please refer to the instruction manual (G230 RC) for more details.,
Ready-to-run
Nitro 4-wd
-speed transmission
Assembled chassis
18cxp engine
Front and rear bevel gear differential
8 special oil-filled shock absorber
Aluminum chassis
Four-wheel drive
Close the fuel tank's cover and fasten it after it after filling the fuel.
Shut down the wind gate, and turn the accelerograph to the position that spaces 1/4-1/3 place of opening;
Pull the pulling-start rod until engine send out sound of start to start engine adjust the wind gate to the place which spaces 1/4 position of opening position;
Pull the pulling-started rod quickly;
Start engine several minutes to prewarm.
Check price and availability
Found 11 years, 8 months ago