NitroTek
F16 64mm RC Jet Vectored PNP Version in Black and Grey
Wingspan | 800mm |
Length | 1020mm |
Wing Load | 35 g/dm² |
Fly Weight | 1100g |
, 7 pcs 9g servos , Brushless motor 2632 out runner KV4100 , 45A ESC 5A UBEC, , , , Pre-painted foam fuselage & wings, Thrust vectoring, 90% assembled, Some Pre-installed electrics, CAD engineering quality, Stunning paintwork, 64 mm electric ducted fan, State of the art components, Can perform amazing aerobatics, ,
This fighter is one of the classics, the F-16 is the one that springs to mind when people think of fighter jets. This one has an 800mm wingspan, vectored thrust and a powerful brushless motor - if you couple this with the 14.8V battery and charger that you'll need to finish the plane (along with a transmitter, and receiver) you are going to be in posession of a very rapid jet!
The Starmax jets are truly large scale, making them not only look amazing, and dramatic but it adds to the stability of the model in the air. For true EDF jet enjoyment you'll find it hard to beat the Starmax.
This one has an 800mm wingspan and a very powerful brushless motor - if you couple this with the 14.8V battery and charger that you'll need to finish the plane (along with a transmitter, and receiver) you are going to be in posession of an extremely rapid model!
The speed of the F16 really has to be seen to be believed, they can be launched from the ground or hand held and as soon as you hit that throttle lever on the transmitter of your choice, this jet will rocket all the way to 80-90mph depending on flight conditions.
The F-16 also has a feature called thrust vectoring. Thrust vectoring is the ability of an aircraft to direct the thrust from its engine(s) in a direction other than parallel to the vehicle's longitudinal axis. The technique was originally employed to provide upward vertical thrust as a means to give aircraft vertical (VTOL) or short (STOL) takeoff and landing ability. Soon, it was realized that using vectored thrust in combat situations enabled aircraft to perform manoeuvres not available to conventional-engined planes. One of the RC channels on this jet allows you to change the direction in which the EDF fan pushes the thrust, meaning that this is one of the most agile EDF jets that money can buy.
Included is an electronic speed controller, ducted fan with electric brushless motor and 7 electric servos all pre-installed. A 4ch transmitter which is required to complete the model gives full 3D control of the aileron, elevator, rudder, throttle, and the vectored thrust. The ducted fan system with the brushless motors gives enormous power pushing the jet to crazy speeds.
The attention to detail from Starmax who are the leading rc jet manufacturers gives the jet a nice realistic appearance. The jet can take off from the ground or can be hand launched. If you are not ready to be flying at high speeds then you can also fly the plane very slowly while you get used to it without any problems. The jet is made from shock resistant EPS foam with reinforced fuselage and strong wings. Should you need any spare parts though they are all available from our site. This plane is a lot of fun and you will certainly enjoy flying this fantastic model.
The power that this plane packs allows it to perform a full aerobatic display: inside loops, outside loops, axial rolls, inverted flight, knife edge, stall turns, hammerheads, and spins are all possible. If you're really good you will be able to perform the famous 'Cobra Manoeuvre' with your AMX.
Check price and availability
Found 11 years, 9 months ago