SDSHobby
Special Flymentor 3D for Helicopter
Specifications:, Working Voltage:, 4.8-6.0V, Working Current:, 55mA (5V), Operating Temperature:, 0, Maximum Rotation Rate under the positioning and Balance Mode:, Aileron and Elevator:, ≤, Swinging Motion of Tail Prop:, ≤, Component:, controller, position sensor and CCD, Functions:, Adjust the working status of Flymentor 3D by AUX Channel, switchable gain system provides three different positions: Off, stabilization and Position-holding mode.,
℃
~ +40
℃
00
°
/ s
360
°
/ s
New type of sensing process provides reliable geographical positioning, completely independent of the visible horizon.
Particular CCD sensor can catch the ground picture to compare, and prevent helicopter from drifting.
Built-in head lock gyro and swashplate mixer.
Control the sensitivity and mode of gyro by GEAR Channel.
Support helicopters with 3S 120 swashplate, or 3S 140 swashplate, or 4S 90 swashplate, or 4S 90 +45 swash plate.
Attitude stabilization in inverted flight.
Set Flymentor 3D by computer USB adapter.
If you use FM/PPM radio equipment, Flymentor 3D will make the ailerons, elevator and tail servo back immediately. The pitch will remain in the final signal position. And Flymentor will switch to position mode automatically. The sensitivity is 70%.
Check price and availability
Found 11 years, 7 months ago