ngHobbies
Double Quadro V3 - Cool
| • voltage | 10 to 30V -> 3 -7S Lipo |
| • current | up to 60A (per BL-Unit) and 120A (all together) with appropriate cooling |
| • Silent Start | test tone at startup can be disabled |
| • hole | 3mm |
| • weight | ca. 109g |
IMPORTANT:, Use FlightCtrl Firmware V2.02 (or greater), otherwise read the instructions in the wiki !, : The BL-Ctrl 3.0 controller is specifically designed and optimized for our motors. For maximum stability of the MikroKopter set-points are set almost instantaneously on the motor. If other motors (especially larger power classes) are used with this controller, this fast change of set-points can easily lead to very high peak currents, which bring the BL-Ctrl control to the limit or an overload. This is no fault of BL-Ctrl3.0 controller, but a systemic property., Power:, Mechanical data:, , • Dimensions (W x H ):, In the package:, • 2 SMD preassembled, programmed and tested boards already mounted and soldered, Links:,
8 ESCs on two boards with extra cooling through assembled heat sink! Extremely fast brushless controllers version V3 for our MikroKopter
The board is tested and programmed (including bootloader)
Note
• 6 -layer PCB for optimal heat dissipation . 70u copper layers make the entire circuit board to the heat sink .
• current limiting and temperature limiting
• Active freewheeling -> less power loss
Fast response with speed control
• rapid acceleration and braking of the propeller. Active and seamless braking gives the speed precisely and quickly on the new setpoint .
• return energy to the lipo when braking. Seamless transition from acceleration to braking
• significantly faster control with speed control
Other Features
• Integrated 12V voltage regulator for external LED-Supply
• Switchable LED output -> LEDs can flash in case of undervoltage
• Adjustable motor timing in several steps of 13-28° - compatible with the most common BL motors
• Adjustable switching frequency ( 10kHz - 20kHz )
• PPM to 500 Hz with simultaneous I2C - bus operation for telemetry and data logging
• Integrated 12V stabilization for LED lighting and other 12V appliances
• Switchable outputs for lighting -> ZB The blinking lights at low voltage
• Software adjustable direction of rotation
• Adjustable current and temperature limits
• Adjustable start-PWM
Interface
• various interfaces for setpoint input ( I2C, PPM ( 500Hz ) , serial)
• Integrated current measurement measurement of the actual current and the used capacity on the Mikrokopter control
• voltage and temperature measurement with data transmission to the ground station and data logging
• 11-bit resolution (2048 steps )
• various feedback to the MikroKopter-FlightCtrl ( blocked motor , power limiting , etc. )
• extented configuration options (eg current limit , temperature limit , ...)
• two LEDs (OK and Error )
• Adressable by loder-jumpers (address 1-8)
• I2C bus access possible in PPM mode - for data logging and telemetry in PPM mode
• status messages are transmitted to the FC ( engine blocks , Current, Self-test error ...)
• current measurement up to 75A per controller
• Convenient configuration of the BL controller via FC
• Lipo Power cable (open ends)
• 1-line cable for LED output control
•
more information in the wiki ...
Check price and availability
Found 10 years, 7 months ago