RCModelScout.

RCTimer

Radio for telemetry Air Module 433Mhz

Documentation:, Radio Configurator(Air module need a USB-UART tool like FTDI to configure):, Board schmatic:, ,

RCTimer Radio for telemetry Air Module 433Mhz

The RCTimer Radio "Air" module is part of the new telemetry system.

It would work in conjunction with the "Ground" module offering a 2-way half duplex wireless communication system.

It base on 3DR Radio system and 100% compatible.

Features

·Small size and light weight

·Available in 433MHz variants

·Receiver sensitivity to -121 dBm

·Transmit power up to 20dBm (100mW)

·Transparent serial link

·Air data rates up to 250kbps

·MAVLink protocol framing and status reporting

·Frequency hopping spread spectrum (FHSS)

·Adaptive time division multiplexing (TDM)

·Support for LBT and AFA

·Configurable duty cycle

·Built in error correcting code (can correct up to 25% data bit errors)

·Demonstrated range of several kilometers with a small omni antenna

·Can be used with a bi-directional amplifier for even more range

·Open source firmware

·AT commands for radio configuration

·RT commands for remote radio configuration

·Adaptive flow control when used with APM

·Based on the HopeRF HM-TRP radio module, featuring an SiLabs Si1000 RF microcontroller.

Other

·
35mm
(no include SMA connector)

·
/
16.8g
(include cable and antenna)

Package content

·
Air Module(433Mhz) x 1

·
UART 4Pin cable
300mm
x1

·
2.5dbi Antenna x1

Found 11 years, 9 months ago