HiModel
FrSky 2.4G 6-channel Two Way Communication Receiver D6FR
| Compatible with FrSky two way telemetry modules | DFT, DJT, DHT, DHT-U |
| Dimension | 42*22*11mm |
| Weight | 7.1g |
| Operating Voltage Range | 4.0V-10.0V |
| Operating Current | 50mA |
| Specified Range | 1.5km |
| Resolution | 3072 (>11bit) |
| Frame Rate | 18ms (FS) |
| Please kindly follow the steps below to perform range check | (Note |
, , , , , , Specifications:, , , , , , , , , , , 1.1 Compatibility:, 1.2 Specification:, 9ms (HS), Setup, 2.1 Bind procedure:, 1) Turn your transmitter on and switch it to PPM mode (if not set). Turn your transmitter off., 2)Turn your transmitter on while holding the F/S button on the transmitter module (Please make sure that both switches on the transmitter module are OFF in two way mode) Release it in a few seconds. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the receiver., 3) Connect battery to the receiver while holding the F/S button on the receiver. The LED on the receiver will flash, indicating the binding process is completed., 4) Turn on the transmitter and connect battery to the receiver. The Green LED on the receiver will indicate the receiver is receiving commands from the transmitter., 2.2 Range check:, It is highly suggested to perform pre-flight range check. Caution must be paid when you perform range check in environment with metal fences, concrete buildings, or rows of trees. Loss of signal may be experienced from reflections., 1) Place the model at least two feet (60cm) above non-metal contaminated ground (like wooden bench)., 2) Place the receiver’s antennas apart. Do not let the antennas touch the ground., 3) Place the antenna of the transmitter in a vertical position., 4) Turn on the transmitter and receiver, press the F/S button of the transmitter for 4 seconds to enter range check mode, the RED LED of the transmitter module will be off, GREEN LED will flash rapidly, the BEEPER will sound. The effective distance will be decreased to 1/30 of full range., 5) Walk away from the model whi,
Features:
Features:
1) Lighter in weight and smaller in dimension.
2) Built-in battery voltage sensor (A1) and additional ADC (A2).
3) Two switchable servo frame speed modes: FS mode and HS mode.
4) Telemetry - Alarm warning on low voltage/poor reception.
5) Telemetry - RSSI.
Includes/Requires:
Includes:1 x receiver DF6R
Check price and availability
Found 11 years, 8 months ago