RCModelScout.

HobbyWireless

FrSky DH-U sensor hub, sensors and LCD-fdd_lite

Details:, DH-U combo DHT-U 2.4GHz telemetry system., Features:, Show in-flight data via in-built display;, Note: Due to incaution, pins definition for Aurora 9 on the guide sheet of "Pins Definition for PPM Signal" going with certain DHT-U combo was mislabeled.,

It's a duplex built-in receiver and 2.4 GHz transmitter module. Just to receive telemetry data from your RC model and control the model at the same time.
All-in-one universal telemetry module, combination of DHT, in-built display and fdd_lite, which can be clamped to the transmitter handle or antennas base.
Capable of setting failsafe during flight.
Time (hour/minute/second)
Fuel Level
Voltage A1/A2
RSSI
Acceleration X/Y/Z
Speed
RPM
Altitude
Temperature 1/2
Voltage (voltage sensor connecting to sensor hub)
Longitude & Latitude
V8_Mode (non-telemetry)/D_Mode (telemetry)
Bind/Normal Working/Range Check
Setting
Failsafe
sensor connecting to sensor hub
Temperature (Celsiu or Fahren)
The alarm thresholds and directions (either above or below threshold) can be programmed by using FrSky LCD-fdd_lite. After alarm thresholds and directions are programmed, click “SEND”. If programmed values keep unchanged, that means these values have been remembered.

Specification

Features

1) All-in-one combination of telemetry module,in-built display and alarm threshold settings

2) DHT-U can be clamped to the transmitter handle/antenna

3) Show in-flight data via in-built display

4) Capable of setting failsafe during flight

5) Firmware upgradable

Package Contents

100% Brand New

1 x DHT-U 2.4GHz Two Way Series

1 x instruction Manual

User's Manual

Pin out fo PPM

Watch some tutorial videos over youtube.

Click here to see correction.
All technical questions about FrSKy products must to be emailed to frsky@frsky-rc.com

Found 11 years, 9 months ago