ReadyMadeRC
Acro Naze 32 - Flight Controller Rev 6
Important Notes:,
*****REVISION (6) ******
This version does not include pins.
You must source your own below, or direct solder your servo leads to the board itself.
To ensure driver compatibility, please connect the board via USB
before soldering any pins
to the board. A good source for drivers that seem to be compatible with the software are Silicon Labs CP210x USB to UART Bridge VCP Drivers, which can be found
HERE
Returns cannot be accepted for poor soldering and bad connections.
Using this hardware with anything other than supplied "baseflight" firmware will immediately make the end user ineligible for any kind of support or warranty through the manufacturer.
NAZE
boards can vary in color from batch to batch. We cannot guarantee which color you will receive.
Be sure to use the BaseFlight software to update and make changes. Click here to download.
This is the Acro version of the Naze32 and does
not
include Barometer or Magnetometer! (Includes Accelerometer & Gyro)
STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
Invensense MPU6050 MEMS accelerometer + gyro
Built-in Micro-USB for programming/firmware update
36x36mm size, ~5 gram weight w/o headers
Made in JAPAN
No headers included. RC input breakout cable is available in the link below to allow connecting to 4 channel+ receiver.
User manual found
HERE
.
Configuration software found
HERE.
(Chrome)
Optional RC breakout cable found
HERE
Need Pin Headers?
Pin Headers - 3 Rows, Right Angle (40 Pins, 2.54 spacing)
Pin Headers - 1 Row, Straight (40 Pins, 2.54 spacing)
This flight controller can be paired with the RMRC Prints FrSky
D4R-II / X4R Antenna Holder
&
Naze Platform
for an incredibly clean & tidy setup.
Check price and availability
Found 9 years ago