ReadyMadeRC
CC3D OpenPilot CopterControl Board by ReadyMadeRC
CC3D from the OpenPilot project introduces a hardware refresh of the highly regarded multi-purpose aircraft stabilization platform. The CopterControl platform has been designed from the ground up to perform the following functions:, A MultiRotor controller with auto-level, including TriCopters, QuadCopters and HexaCopters, The CopterControl hardware has the following features:, Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM, For info:,
CopterControl 3D (CC3D) from the OpenPilot project introduces a new generation of multi-purpose aircraft stabilization platforms
Manufactured with approval from David Ankers by Ready Made RC, LLC, these are fully tested with firmware pre-loaded, These open source stabilization boards offer great communitty support.
To help continue the development of these and future hardware/software, ReadyMadeRC is donating $10USD for every single CC3D board we produce to the OpenPilot project. By doing this, it will help the developers gain the resources needed to add functionality and features that we will all be able to enjoy!
A Flybarless Helicopter controller with auto-level - Experimental
A Fixed Wing UAV controller - Experimental
Package Includes
1 x OpenPilot CopterControl Board
1 x OpenPilot Serial Cable
1 x OpenPilot CopterControl RC Receiver Cable
3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer
OpenPilot's innovative 36mmx36mm board size
Software support for Windows, Mac and LinuxDirect high speed USB support with no drivers required, a truly plug and play device.
Spektrum satellite receiver support
Futaba S-BUS hardware support
Innovative Flexi-port technology for superior port flexibility
16Mbits on-board EEPROM for configuration storage
Open Pilot Project Page
Open Pilot Forums
Getting Started
Check price and availability
Found 11 years, 5 months ago