ReadyMadeRC
CXN - GoPro Hero3 + FPV Camera Pan & Tilt Version 2
IMPORTANT: Servo measurements are different between brands, this mount was designed using this servos below (you can use other brands just be sure to,
This version is made only for the Hero 3 or 3+, laser cut ABS plastic for durability and strength has the tilt servo in the center of gravity and its direct connected to the pan base, there is no stress on the servo or loose servo arms to cause vibrations. The camera is held in place with a little bar in the back secured by one screw.
Pan can be used with any Standard size servo, but you have the option of adding 4 supports on the PAN base that will reduce the chance of any vibrations or "wobble" caused by wind when you are panning. These 4 supports were designed around the
GWS S125 1T 2BB Sail Winch Servo
(360 degree servo
used for FPV). The 4 supports are meant to be used with a GWS 360 degrees servo
ONLY
or similar servo with the same height. Other servos might have different heights and will not be supported correctly.
match the measurements).
PAN SERVO
= GWS S125 1T 2BB Sail Winch Servo (360 degree servo)
The GWS servo only comes with a pulley,
YOU NEED A Spektrum or JR servo horn
to attach the servo to the PAN base or you can modify the winch pulley.
TILT SERVO
= 9g metal gear servo.
SERVOS and CAMERAS NOT INCLUDED.
Instruction Manual
Check price and availability
Found 10 years, 10 months ago