RangeVideo
FrSKY 2.4GHz JR Combo Pack
| Power consumption | 50mA |
| Resolution | 3072 (11bit) |
| Dimensions | 63.9x48.5x36.5mm |
| Receiver specification | Model |
| Operating Voltage Range | 3.0V-16.0V |
| Operating Current | 30mA |
| Resolution | 3072 |
| Latency | 22ms |
| Specified | 7CH, 9g, 49mm×23mm×12mm |
| Warning | DO NOT connect servos to channel 8, otherwise servos will get hot or even burn out. |
Description:, FrSKY ACCST technology is proven, approved by many model associations, tested and reviewed as the leading Chinese 2.4Ghz R/C Technology. If you think DSM2 or FASST is the best, think again!, Purchase includes:, (1) 8-channel transmitter module V8JT, Features:, Advanced Continuous Channel Shifting Technology (ACCST is our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility., Transmitter Module is compatible with the following transmitters:, FrSky V8JT is compatible with JR transmitters following:, JR: 347, 388, 783, U8, PCM10, PCM10S, PCM10SX, PCM10IIS, 8103, J9303, MX 22, MX-24S, PX, 9XII, Transmitter module specification:, Operating voltage:, 6.0V-13.0V (can handle 3S!), Output Power:: 60mW, Bind Procedure:, , Failsafe:, , V8R7-SP supports failsafe function for all channels. Just do it as bellow:, After the receiver has been bind, press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, the failsafe is set up successfully.,
Details
New FrSKY ACCST (Advanced Continuous Channel Shifting Technology) gives you secure radio communicatios in 2.4Ghz band. ACCST 2.4GHz system shifts 80 channels around hundred times per second in the 2.4GHz band. This means that the system is completely resistant to interference in that band.
V8R7-SP receiver has a combined PPM output on channel 8, which lets you connect the receiver to RVOSD G5 / Mikrokopter flight controller using a single wire, instead of connecting each channel individually.
(1) 7-channel receiver
W/PPM Output V8R7SP
(1) 2dBi transmitter antenna (RP SMA)
Easy to bind and very fast link-up.
Excellent reboot time.
True Diversity with two antennas.
All channels can be programmed with Failsafe, quickly and easily.
Quick and extremely stable in performance.
Precise and smooth servo response.
1) Turn on your transmitter and switch it to PPM mode, turn off the TX.
2) Turn on your transmitter while holding the programming button. Release it a few seconds later. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind the receiver.
3) Connect the battery to the receiver while holding the receiver’s F/S button. The LED on the receiver will flash, indicating the binding process is complete. Turn off the transmitter and receiver.
4) Turn on your transmitter. Connect the battery to the receiver when ORANGE LED on TX is on. The LED on the receiver will indicate the receiver is receiving commands from the transmitter. In a few seconds system is ready to work (communication is established).
Binding is required only to set up a new link (like new or additional receiver or transmitter module). To control multi-receivers, every receiver should be programmed with the transmitter in binding state.
If you do not need the failsafe function any more, just re-bind the receiver.
RP SMA connector.
7CH receiver with PPM stream output.
Check price and availability
Found 11 years, 3 months ago