ReadyMadeRC
Nemesis 240mm FPV Quad - Carbon Fiber
| Motors | Tiger MN 1806 2300kv (3s-4s) , |
| ESCs | 10-12A |
| Prop | 2 blade 5030 Gemfan, 2 Blade 5 x 4 HQ Composite, 2 Blade 6030 HQ Composite |
| Flight Controller | Naze32 Acro, OP CC3D |
Standard Frame features:, -Vibration free separated Clean and Dirty sections for smooth video recording, -Intelligent Electronics management: tons of options for mounting electronics including Buzzers, Strobes, leds, voltage readers, OSD, access Mobius buttons when mounted inside frame, etc, The standard frame kit includes:, -1 Top Clean Plate (1mm), Recommended Equipment:,
-Instantly fully inward fold-able quad for easy pack and go and crash protection
-Lightweight frame design but still able to take hard hits
-Unique custom folding and extending arm mechanism allows both 5" and 6" props
-4 predefined flight configurations for wings, X compact, H compact, X extended, Superman
-Alignment/locking holes for H in 5", X in 5", X in 6"
-Unique ability to dirty or clean mount your flight controller (supports 45mm and below FCs)
-2 Stage Bobbin travel limiter
-Built in Mobius/GoPro1-3+ mounts integrated into frame and accessories
-Dedicated Board Camera and rear bulkhead plates
-Accessory Shelf with 3 mounting positions, (you can use up to 3 at once)
-Extension plate for mounting Mobius, GoPro, InfinityCam One, CCD flight cam out front, bolts in 2 locations
-Multiple SMA jack mounts including a unique rear bulkhead mount
-Extended lower front spoiler on dirty section for frontal crash impact absorption
-Clean wiring, all ESCs mount inside center frame as well as flight controller, fits Bt408 mini PDB perfectly inside
-Battery can be top mounted or mounted inside the clean section
-Integrated mounting points (2 locations) for Landing Gear/Standoffs
-Optional upgrades TBA later
-1 Bottom Clean Plate (1mm)
-1 Top Dirty Plate (1.5mm)
-1 Bottom Dirty Plate (1.5mm)
-4 Adjustable extending Arms (3mm)
-1 CCD Camera Plate (1mm)
-1 Rear Bulkhead Plate (1mm)
-1 Stacking Accessory Shelf/Plate (1mm)
-1 Camera front Extension Plate (1.5mm)
-All hardware required to assemble frame
4 x M4x14mm (arms)
4 x M4 Nylock Nuts (arms)
4 x M2X10mm (Dirty Section)
4 x M2 Standard or Nylock Nuts (dirty section)
4 x High Quality Vibration Dampers
8 x M3 Standard Nuts (bobbins)
16 x M3x6 or M3x8 button head (clean section)
8 x M3x35mm standoffs (clean section)
4 x M2x3mm spacers (dirty section)
DualSky ECO 2204 2300kv
INSTRUCTIONS
Check price and availability
Found 10 years, 2 months ago