RCModelScout.

Flying-Hobby

Scorpion Brushless Motor HKIII-4035 KV560 (Logo 600/ Heli 700 Size)

The Scorpion HKIII-40 Series Motor* is designed for using on 700 class helicopters running on 12-cell Li-Po power. This motor represents the most technologically advanced power source ever offered for a 700 class electric helicopter.

Scorpion Competition Series Brushless Motors are built from the best materials available, and are designed to provide both

quality and performance at an affordable price. Scorpion starts with high quality aluminum alloy parts that are produced on the latest CNC milling machines. These parts are then gold Electro-Coated to provide a beautiful, long-lasting finish. The stators are made with 0.2mm laminations to give maximum efficiency, and minimum Eddy current losses. The stators are epoxy coated to prevent shorts, and are wound with wire that is rated at 180 degrees C (356 F). The magnets used in Scorpion Motors are rated for operation at 200 degrees C (392 F), making a motor that is virtually impossible to burn up in normal use.

Scorpion Motors are built to last, and are backed with a 2-Year warranty against defects in materials or workmanship. However, due to the high RPM of these motors, and the fact that we cannot control the installation and setup, the bearings are not covered by the 2-Year warranty, nor is any subsequent damage caused to the motor by a bearing failure. Bearings are a normal wear item, and as such, need to be maintained and changed periodically. For maximum life, make sure that a sufficient gap is left between the pinion and main gear during motor installation to avoid binding, and put a small drop of oil on each bearing every 5-6 flights. It is the responsibility of the pilot to ensure that the bearings are maintained properly.

For the best overall combination of quality, performance, and value, uses Scorpion Motors in your helicopter!

*This motor is using 30mm*25mm bolt spacing on the mounting with M4 Screw holes

Specifications

Stator Diameter

40 mm (1.56 in)

Stator Thickness

35 mm (1.024 in)

No. of Stator Arms

12

Magnet Poles

10

Motor Wind

8 Turn Delta

Motor Wire

23 - Strand 0.29mm

Motor Kv

560KV RPM / Volt

No-Load Current (IO)

2.24 Amps @ 10v

Motor Resistance (RM)

0.014 Ohms

Max Continuous Current

100 Amps

Max Continuous Power

4200 Watts

Weight

460 Grams (16.22 oz)

Outside Diameter

49.98 mm (1.97 in)

Shaft Diameter

5.98 mm (0.235 in)

Body Length

61.8 mm (2.43 in)

Overall Shaft Length

100.0 mm (3.93 in)

Max Lipo Cell

12s

Peak Current

120A (5 seconds)

Peal Power

5200 Watts (5 seconds)

Motor Timing

5deg

Drive Frequency

8kHz

Weight including packaging

607g

Found 11 years, 3 months ago