SDSHobby
ZTW Spider-Series 50A OPTO Brushless ESC 3S-6S for Multi-Rotor Helicopter
| Attention | This ESC |
Calibration of throttle:, 1. Let flight control come into throttle calibration state or directly use throttle concentrator. For APM, first turn on the remote control, the throttle will be maximum state, then turn on APM and wait for 1 minute; then power on after APM is power failure., Features:, Overview:, ZTW Spider OPTO ESC,
is not including BEC
, and then it can not directly supply power to receiver.
The multicopter is generally connected with flight control, and then the receiver will be power supplied by flight control.
The ESC does not need to set throttle route because there is a small counter code inside. It can recognize automatically
.
. Turn on the remote control, the throttle will be maximum state, when you listen to “di” voice, pull the throttle to the minimum and you will hear “di di”, then the calibration is finished.
Extremely low internal resistance
Super smooth and accurate throttle linearity
Safety thermal over-load protection
Auto throttle shut down in signal lose situation
Supports high RPM motors
Power arming protection (prevents the motor from accidentally running when switched ON)
Use new generation of the MOSFETs to make sure the ESC with low heating and more reliability
is quality speed controllers and designed for simple installation and easy setup. These ESCs have been proven to offer excellent performance in Multi-rotor applications.
These ESC's features a very smooth yet linear throttle response, without sacrificing a rapid, crisp, and response to any throttle input. Super fast refresh rate up to 600Hz makes them a very smooth controller. That is to say
support PWM input rates up to 600Hz
for great response on your quad-copter. Fashion design and high quality with best performance but sold at very reasonable price.
Check price and availability
Found 10 years, 7 months ago