Skip to content
Discountinued

ReadyMadeRC

Radian FPV Pan/Tilt Pod Kit


ManualHERE

When purchased with the pan/tilt kit, comes with a mounting plate that will fit many popular FPV cameras including:, , Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., This kit will include:, , Note: for the "no servo" option, it is up to the customer to modify the assembly if required.  The system was designed for HXT900/TG9e servos.  Any other servo must be aligned properly for proper gear engagement., You'll need to supply:, ,

A Parkzone Radian and Radian Pro FPV pod that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher.  A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below).

The pods are supplied with quality TG9e servos.  For better resistance to crash damage, and for better tolerance of 900MHz video systems, HS-65HB servos are available as an upgrade option below.

A space at the front of the pod is available for your battery if you can adjust the CG of the Radian enough to accommodate the weight up front, otherwise the video battery can be placed inside the fuselage.  Note that it is likely that some adjustments to the stock battery location will be required to maintain the proper center of gravity for the plane

The pod is attached to the Radian by a combination of the tabs at the front of the pod and strong rare-earth magnets (included) at the back of the pod.

RMRC-420, RMRC-420XV, RMRC-520, RMRC-LL600, KX131, KX171, KX191, IF Cam, SN777, SN555 and others

Additional back plates may be purchased
here
to fit RMRC-480, RMRC-540, IF OSD Cam, DPC OSD Cam, DX201

If you need to mount a camera not listed, please send me a message via the "Contact Us" link to the left.

Laser cut components for the main pod

Laser cut components and hardware for the 180 degree pan module

Two 9g Servos

Four rare-earth magnets

Velcro strap to hold battery to pod

A single standard camera back plate and hinge/control arm

Double sided servo tape to apply TX, camera, and tilt servo.

Pull-ties to hold TX against tape and for holding your wiring down.

Medium CA

5 minute epoxy

*No pan/tilt module option will come with laser cut parts for pod, four rare earth magnets, and velcro strap.


Check price and availability


Found 11 years, 8 months ago



Related Products


Radian FPV Pan/Tilt Pod Kit

View
Radian FPV Pan/Tilt Pod Kit

ImmersionRC FPV EZAntenna Tracker (for EzOSD)

View
ImmersionRC FPV EZAntenna Tracker (for EzOSD)

FPV Flight Simulator Joystick - FPV 1.5 Interface ...

View
FPV Flight Simulator Joystick - FPV 1.5 Interface - X-Gyro 1500

Eagle Eyes FPV Station with Plastic Case

View
Eagle Eyes FPV Station with Plastic Case

TwinStar FPV Pan/Tilt Pod Kit

View
TwinStar FPV Pan/Tilt Pod Kit
BevRC DPCAV Hobby-Lobby HobbyKing LowPriceRC ngHobbies NitroTek R2Hobbies RangeVideo RCTimer ReadyMadeRC HobbyWireless RCPlanet HorizonHobby HiModel OFM GetFPV AMainHobbies SDSHobby GoodLuckBuy Flying-Hobby