ngHobbies
Radian FPV Pan/Tilt Pod Kit
| Comes with a mounting plate that will fit many popular FPV cameras including | KX131, KX171, KX191, IF Cam, SN777, SN555 and many others |
| Instructions to build the pan and tilt | Coming Soon |
Note:, careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., This kit will include*:, Laser cut components for the main pod, You'll need to supply:, Double sided servo tape to apply TX, camera, and tilt servo., Documentation:,
The Radian FPV pod that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below).
A support at the rear of the pod is available for your battery(two locations to choose from!). Although designed for a 620mAh 3s battery, many other batteries will fit in this compartment.The pod is attached to the Skywalker by a combination of the tabs at the rear of the pod and a thumb screw (included) at the front of the pod that attaches to the blind nut that comes with the SkyWalker. There are two locations for the pan/tilt assembly. You can choose a normal or forward location during assembly (see pictures).
Additional back plates may be purchased to fit IF OSD Cam, DPC OSD Cam, DX201
Laser cut components and hardware for the 180 degree pan module (or other options available)
Two 9g Servos (if choosing a pan/tilt option with basic servos)
Thumb screw and retaining clip
Velcro strap to hold battery to pod
Pull-ties to hold TX against tape and for holding your wiring down.
Medium CA
Check price and availability
Found 11 years, 9 months ago