ngHobbies
Twinstar FPV Pan/Tilt Pod Kit
Comes with a mounting plate that will fit many popular FPV cameras including: KX131, KX171, KX191, IF Cam, SN777, SN555 and others. Additional back plates may be purchased here to fit IF OSD Cam, DPC OSD Cam, DX201, Note:, careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., This kit includes:, Laser cut components for the main pod, You'll need:, Double sided servo tape to apply TX, camera, and tilt servo., Documentation:, Instructions to build the pan and tilt:, Click here, Instructions to build the Twinstar Pod:, Coming soon,
a Twinstar FPV pod that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of our SSV3.5 servo stretcher.
A compartment at the rear of the pod is available for your battery. Although designed for a Rhino 620mAh 3s battery, many other batteries will fit in this compartment.
The pod is attached to the Easy Star by a combination of the tabs at the front of the pod and strong rare-earth magnets (included) at the back of the pod.
The pod is attached to the TwinStar by a combination of the tabs at the rear of the pod and strong rare-earth magnets (included) at the front of the pod.
Laser cut components and hardware for the 180 degree pan module
Two 9g Servos
Four rare-earth magnets
A single back plate and hinge/control arm for your camera (choose below)
Pull-ties to hold TX against tape and for holding your wiring down.
Medium CA
5 minute epoxy
Check price and availability
Found 11 years, 9 months ago