RCModelScout.

HiModel

KYOSHO GXR-18 ENGINE W/RECOIL STARTER FOR CARS

, , , , , , Specifications:, , , , , , , , , , , * Note: As this engine is produced as OEM from ASP for Koyosho, the outer box you receive may with ASP marks, this is not a mistake., ● Engine starting & break-in, Adjust the needle valve and air/fuel mixture adjustment screw to their standard position as follows:, ② Air/fuel mixture adjustment: Gently screw in the idle mixture screw to closed position (clockwise); 2 and 1/2 turns unscrewed from closed position (counter clockwise), Adjustments ① ~ ② may slightly vary according to the type of glow plug and glow fuel., Proceed as follows when starting and breaking the engine in:, 1. Make sure the needle valve is unscrewed 2-1/2 turns from closed position., 2. Fill fuel into the tank. Move the throttle lever to the high position, prime the engine (push the choke button 2 to 3 times or put 2 to 3 drops of fuel directly into the carburetor) and move the throttle lever back to the slow throttle position., 3. Attach the booster cord or one-touch glow plug heater to the engine in order to electrify the glow plug., 4. Quickly pull the recoil starter rope (starter knob) several times. Only pull out 20 to 30cm of cord., (Caution: be careful not to pull out more than 50cm of cord because you may tear it and the spring inside the recoil starter!), 5. Once the engine is started, wait 5 to 10 seconds before detaching the booster cord or one-touch glow plug heater., 6. Run the engine another 2 to 3 tanks and make sure you do not apply full throttle. Also afterwards, do not increase RPM abruptly! Tighten the needle valve by 1/8 turns and continue to run the engine, handling it gently., 7. During the break-in, adjust the idle rpm with the throttle valve adjustment screw.. If rotating it clockwise (right), idle rpm increase. Idle rpm are halfway between rpm when the clutch engages and rpm when the engine stalls. Set idle rpm towards the lower end if possible., 8. No,

HobbyKing

MINI PLUG EXTENTION FOR MICRO BATTERY 10CM (5PCS/BAG)

HobbyKing

TURNIGY 160MAH 1S 30C (EFLITE, MINIUM COMPATIBLE)

: 160mAh, : 1S / 1 Cell / 3.7v, : 30C Constant, : 4.3g (including balance & discharge plug), : 37x12x6mm, : JST-XH,

R2Hobbies

EURGLE 7.4V 2S2P 35C 5200MAH RC CAR PERFORMANCE LITHIUM POLYMER LIPO BATTERY

HobbyKing

PLUG-KING MULTI-19 MEGA CHARGE PLUG ADAPTER SET

,

HobbyKing

MICRO JST PARALLEL CHARGE LEAD (6 PLUGS)

,

HobbyWireless

TURNIGY 160 MAH 1S 3.7V 30C POWER SYSTEMS BATTERY

Details:, Upgraded capacity and discharge curve., : 160mAh, : 1S / 1 Cell / 3.7v, : 30C Constant, : 4.3g (including balance & discharge plug), : 37x12x6mm, : JST-XH,

HobbyWireless

HYPERION CX G3 180 MAH 1S 3.7V 25C LIPO

Details:, Hyperion GENERATION 3, 180mAh 25C/45C Single Cell - 4.0A Continuous,

RCPlanet

AQUACRAFT 12V PEAK CHARGER REEF RACER 2 AQUP9929

, Input Voltage:, 12-14.5V DC, Output Voltage:, 8.4V DC, Power Cord Length:, 6' (1.8m), ,

Hobby-Lobby

(AIRIUM BF 109) MAIN WING SET

,

RCPlanet

VENOM 30C LIPO 11.1V 3200MAH BATTERY & DURATRAX ONYX 230 VNR15038-DTXP4230

, Battery - VNR15038, Battery Type:, Lithium Polymer (LiPO), Configuration:, 3S1P, Weight:, 10.22 oz (290g), Dimensions:, 138x25x47mm, Charge Rate:, 1C (3.2A), Continuous Discharge:, 30C (96A), Min Discharge Volts Per Pack:, 9V, Max Burst Rate:, 60C (192A), Max Volts Per Cell:, 4.2V, Max Volts Per Pack:, 12.6V, Watt Hours:, 35.52, Charger - DTXP4230, AC Input:, 110V AC 60Hz, DC Input:, 11-15V DC, built-in lead with alligator clips, Battery Types:, 1-8 NiCd or NiMH cells (1.2-9.6V) 1-3 cell LiPo, or LiFe (3.7-11.1V), Battery Capacity Range:, 50-9900mAh, Fast Charge Current:, 0.1A, 7.0A linear adjustable (50W max., 2C limit for Lithiums), Fast Charge Termination:, Peak detection for NiCd/MH, CC/CV for Lithium, Fast Charge Safety Timer:, OFF-300 minutes, Peak Sensitivity:, 3 - 20mV adjustable, Trickle Charge Current:, Automatic 1/20 fast charge setting (0-250mAh), Input Control:, 4-pushbuttons, Battery Memories:, 10, Setup Tones:, ON/OFF, Display Type:, 2x8 reversed LCD with backlight, Audible Melodies:, 5, Protective Devices:, Solid-state reverse polarity and current overload, Case size:, 6.0 x 5.28 x 1.69 inches (153 x 134 x 43mm), Weight:, 23.5oz (666g), ,

RCPlanet

VENOM 20C 2S 4500MAH 7.4V LIPO BATTERY & DURATRAX ONYX 230 VNR15073-DTXP4230

, Battery - VNR15073, Weight:, 11.3 oz. (320.4 g), Battery Type:, Lithium Polymer (LiPO), Configuration:, 2S1P, Dimensions:, 25.1 x 46.5 x 138 mm, Plug Type:, Venom Universal Plug System, Capacity:, 4500mAh, Charge Rate:, 1C (4.5A), Continuous Discharge:, 20C (90A), Min Discharge Volts Per Pack:, 6.0V, Max Burst Rate:, 40C (180A), Max Volts Per Cell:, 4.2V, Max Volts Per Pack:, 8.4V, Watt Hours:, 33.3, Charger - DTXP4230, AC Input:, 110V AC 60Hz, DC Input:, 11-15V DC, built-in lead with alligator clips, Battery Types:, 1-8 NiCd or NiMH cells (1.2-9.6V) 1-3 cell LiPo, or LiFe (3.7-11.1V), Battery Capacity Range:, 50-9900mAh, Fast Charge Current:, 0.1A, 7.0A linear adjustable (50W max., 2C limit for Lithiums), Fast Charge Termination:, Peak detection for NiCd/MH, CC/CV for Lithium, Fast Charge Safety Timer:, OFF-300 minutes, Peak Sensitivity:, 3 - 20mV adjustable, Trickle Charge Current:, Automatic 1/20 fast charge setting (0-250mAh), Input Control:, 4-pushbuttons, Battery Memories:, 10, Setup Tones:, ON/OFF, Display Type:, 2x8 reversed LCD with backlight, Audible Melodies:, 5, Protective Devices:, Solid-state reverse polarity and current overload, Case size:, 6.0 x 5.28 x 1.69 inches (153 x 134 x 43mm), Weight:, 23.5oz (666g), ,

RCPlanet

VENOM LIPO 3S 1P 11.1V 1300MAH BATTERY & DURATRAX ONYX 230 VNR15024-DTXP4230

, Battery - VNR15024, Min Discharge Volts Per Pack: 9V, Charger - DTXP4230, Battery Memories: 10, Audible Melodies: 5, , ,

RCPlanet

TEKNO RC V4 BRUSHLESS KIT RC8B 42MM MOTORS TKR4501

, ,

RCPlanet

TEKNO RC V4 BRUSHLESS KIT FOR LOSI 8T (TRUGGY, 1.0/2.0, 42MM MOTORS) TKR4508

, ,