RCModelScout.

Hobby-Lobby

ROUND BRASS TUBE 36" - 5/32"

,

Hobby-Lobby

ROUND BRASS TUBE 36" - 3/32"

,

Hobby-Lobby

ROUND ALUM TUBE 36" - 3/16"

,

Hobby-Lobby

STREAMLINE TUBE 35" - 1/2"

,

Hobby-Lobby

STREAMLINE TUBE 35" - 3/8"

,

Hobby-Lobby

ULTRASTRIPE, CUB YELLOW 1/8"

,

Hobby-Lobby

ULTRASTRIPE, CUB YELLOW 1/16"

,

Hobby-Lobby

ULTRACOTE GREEN

Temp ranges are as follows:, Adhesion to wood begins at 200 to 220 degrees F., Key Features:, High tech polyester covering, Temp ranges are as follows:, Adhesion to wood begins at 200 to 220 degrees F., Surface Preparation:, The covering job can only be as good as the finish of the surface it's applied over. In order for the covering to properly adhere to a surface, the surface must first be smooth and clean. Sand the model using a sanding block and progressively finer sandpaper, with the final sanding being done with 320 grit paper. Vacuum away all of the dust, as specks of dust under the covering will leave unsightly bumps. Fill gaps and dents with a high-quality filler. If using light-colored UltraCote (such as white or yellow), use a tan-colored filler that matches the wood color to prevent the filler from showing through., Trim Film to Size:, Start by covering the bottom of one wing half. Using scissors or sharp hobby knife, cut a piece of UltraCote a few inches larger than needed to cover the wing. Remove the backing (save for later) and place the covering with the adhesive (dull) side down, centered over the wing. Set the covering iron to the application temperature of 220�F., Tacking Covering to Spar:, Tack the covering to the spar or the high point of the wing, using your iron as shown (an iron sock is highly recommened). Gently pull the covering toward the root and toward the tip, as you work the iron from the center of the spar to the root and tip of the wing. Press gently with the iron, allowing the heat (not pressure) to activate the adhesive and bond the covering to the high point. Ideally, the covering will naturally lay flat against the entire surface with a minimum of wrinkles., Covering a Solid-Sheeted Wing:, If covering a solid-sheeted wing, work from the center of the spar outward to the trailing edge and then to the leading edge as shown, using the iron at 220�F. If a wrinkle develops, the covering can be carefully lifted and reapplied., Covering an Open-Structure Wing:, If covering an open-structure wing, ,

Hobby-Lobby

INSTA-FLEX CLEAR GAP FILLING CA, 2 OZ.

,

Hobby-Lobby

DJI NAZA WITH GPS

FOR MULTI-ROTOR ONLY: All-in-One Design integrates inner damping, controller, gyroscope, accelerometer and barometer, which simplifies installation and saves space., Technical Specifications:, Basic Performance:, Supported Multi-rotor Quad-rotor I4, X4 / Hex-rotor I6, X6, IY6, Y6, VU: 7.2V ~ 26.0 V (recommend 2S ~ 6S LiPo), Flight Performance:, Max Yaw Angular Velocity 200/s, VU:20g, VU: 32.2mm x 21.1mm x 7.7mm,

Hobby-Lobby

36-INCH SERVO EXTENSION

,

Hobby-Lobby

12" SERVO EXTENSION

,

Hobby-Lobby

HEAVY-DUTY SERVO EXTENSION 6"

,

Hobby-Lobby

6" EXTENSION, LIGHTWEIGHT

Hobby-Lobby

AILERON EXT 6IN TWISTED WIRE

,