ngHobbies
Ardupilot Mega MinimOSD Rev. 1.1
| Dimensions | 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H |
| NOTE | This product is not compatible with the APM 2.0. |
It features two independent power and ground sections to isolate the OSD's analog stage:, a +5V section for the ATmega and the OSD's digital stage, powered through the FTDI cable or other +5V source; and a regulated +5V section for the OSD's analog stage, powered through the video in/out header and capable of handling up to +12V input. Solder jumpers are available to combine the two power and ground sections if desired., Set up instructions:, click here to download or open,
MinimOSD,
a minimal Arduino-based on-screen display board. It's tailored for use with ArduPilot Mega and the MAVlink protocol, and designed to be as compact as possible.
It's main components are an ATmega328P 8 bit microcontroller with an Arduino bootloader, and a MAX7456 monochrome on-screen display. Programming is done through an FTDI-compatible 6-pin cable.
Starting on 4/30/2012, all boards are version 1.1, which reflects a change in the voltage regulator to deal with excessive heating issues.
Specifications
ATmega328P with Arduino bootloader
MAX7456 monochrome on-screen display
FTDI cable compatible pinout
Standard 6-pin ISP header
Two independent power sections with an LED indicator on each
Solder jumpers for combining the power sections
+5V 500mA regulator for up to +12V supply input
Solder jumper for PAL video option
Exposed test points for HSYNC and LOS
Documentation
An alternative firmware with additional features is
minimosd-extra.
Eagle files are
here
.
Dimensional drawings
Check price and availability
Found 11 years, 9 months ago