ReadyMadeRC
Easy Glider FPV Pan/Tilt Pod Kit
| Manual | EasyGliderPod |
When purchased with the pan/tilt kit, comes with a mounting plate that will fit many popular FPV cameras including:, RMRC-420, RMRC-420XV, RMRC-520, RMRC-LL600, KX131, KX171, KX191, IF Cam, SN777, SN555 and others, Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., This kit will include:, , Note: for the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for HXT900 servos. Any other servo must be aligned properly for proper gear engagement., You'll need to supply:, ,
An Easy Glider FPV pod that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below).
The pods are supplied with quality HXT900 or TG9 servos. For better resistance to crash damage, and for better tolerance of 900MHz video systems, HS-65HB servos are available as an upgrade option below.
A support at the rear of the pod is available for your battery. Although designed for a Rhino 620mAh 3s battery, many other batteries will fit in this compartment.
The pod is attached to the Easy Glider PRO or standard Easy Glider by a combination of the tabs at the rear of the pod and strong rare-earth magnets (included) at the front of the pod.
Additional back plates may be purchased
here
to fit RMRC-480, RMRC-540, IF OSD Cam, DPC OSD Cam, DX201
If you need to mount a camera not listed, please send me a message via the "Contact Us" link to the left.
Laser cut components for the main pod
Laser cut components and hardware for the 180 degree pan module
Two 9g Servos
Four rare-earth magnets
Velcro strap to hold battery to pod
A single back plate and hinge/control arm for your camera (choose below)
Double sided servo tape to apply TX, camera, and tilt servo.
Pull-ties to hold TX against tape and for holding your wiring down.
Medium CA
5 minute epoxy
*No pan/tilt module option will come with laser cut parts for pod, four rare earth magnets, and velcro strap.
Check price and availability
Found 8 years, 10 months ago