Easy Star FPV Pan/Tilt Pod Kit

Discountinued

ReadyMadeRC

Easy Star FPV Pan/Tilt Pod Kit

Manual	EasyPod

When purchased with the pan/tilt kit, comes with a mounting plate that will fit many popular FPV cameras including:, , Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation., This kit will include*:, , Note: for the "no servo" option, it is up to the customer to modify the assembly if required. The system was designed for HXT900 servos. Any other servo must be aligned properly for proper gear engagement., You'll need to supply:, ,

An Easy Star FPV pod that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher. A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below).

The pods are supplied with quality HXT900 or TG9 servos. For better resistance to crash damage, and for better tolerance of 900MHz video systems, HS-65HB servos are available as an upgrade option below.

A compartment at the rear of the pod is available for your battery. Although designed for a Rhino 620mAh 3s battery, many other batteries will fit in this compartment.

The pod is attached to the Easy Star by a combination of the tabs at the front of the pod and strong rare-earth magnets (included) at the back of the pod.

RMRC-420, RMRC-420XV, RMRC-520, RMRC-LL600, KX131, KX171, KX191, IF Cam, SN777, SN555 and others

Additional back plates may be purchased
here
to fit RMRC-480, RMRC-540, IF OSD Cam, DPC OSD Cam, DX201

If you need to mount a camera not listed, please send me a message via the "Contact Us" link to the left.

Laser cut components for the main pod

Laser cut components and hardware for the 180 degree pan module

Two 9g Servos

Four rare-earth magnets

Velcro strap to hold down battery

A single back plate and hinge/control arm for your camera (choose below)

Double sided servo tape to apply TX, camera, and tilt servo.

Pull-ties to hold TX against tape and for holding your wiring down.

Medium CA