SDSHobby
HOBBYWING SEAKING 25A BRUSHLESS ESC FOR BOAT (VERSION2.0) WITH WATER COOLING SYSTEM
| Output Continuous Current | 25A |
| Output Burst Current | 50A |
| Input | 5-9 cells Ni-MH/NiCd or 2-3 cells Li-Po |
| BEC Output | 6V/ 1.5A |
| BEC Mode | Linear |
| Suitable Motor | Sensorless Brushless Motor |
| Water Cooling Pipe | 4.0mm (external diameter) |
| Size | 48mm (L) * 35mm (W) * 20mm (H) |
| Weight | 48g |
| Multiple program methods supported | Transmitter stick, LED Program Card. Very easy to program the ESC at home or at the racing field. |
Specifications:, Features:, Multiple protection features: Low voltage cutoff protection to prolong the battery life / Over-heat protection / Throttle signal loss protection.,
"Seaking" series ESC has water-cooling heat-sink and the whole ESC ...SDSHobby
IMPORTED HAND PULLING STARTER FOR JAPAN ZENOAH ENGINE 26CC
,
Hand Pulling Starter for Japan Zenoah Engine 26CCSDSHobby
JOINT FOR CHINA & JAPAN ZENOAH ENGINE 26CC LENGTH=53MM A=6M B=5*5MM
Specifications:, L1=53mm, Application Fields:, M6 diameter for connecting Zenoah engine shaft, 5*5mm diameter for connecting drive shaft.,
D1=M6 D2=5*5mmSDSHobby
LEOPARD 2030-12T KV7780 4 POLES INRUNNER BRUSHLESS MOTOR FOR RC CAR/ RC BOAT
| KV (RPM/V) | 7780 |
| Extended Shaft Diameter (mm) | 2.3 |
| Banana Plug Diameter(mm) | 3.5 |
| Installation Hole Depth(mm) | 2.5 |
| Max Power (W) | 130 |
| Resistance (ohm) | 0.0325 |
| No-load Current(7.4V) | 2.2A |
Specification:, Motor Diameter (mm): 20, Motor Length (mm): 30, Extended Shaft Length (mm): 10, Weight (g): 50, Max Current(A): 18, Recommended Equipments (need to buy separately):, Li-Po Battery: 2S,
SDSHobby
MIDDLE-SIZED SERVO MOUNT(FOR 225MG SERVO )
,
middle-sized Servo mount(for 225MG servo ) Length=52mm Widc.=24mmSDSHobby
M5 RUBBER MOUNT (RUBBER DIA. =14MM RUBBER LENGTH=13MM) FOR ENGINES OF RC MODEL BOAT 4PCS
,
Rubber mount Dia.=14mm L=13mm 4PcsSDSHobby
MOTOR MOUNT WITHOUT WATER COOLING FOR MOTORS OF RC MODEL BOAT
:,
Specifications L1 = 47mm L2 = 28mm D = 13mm ...SDSHobby
MOTOR MOUNT H=25MM FOR MOTORS OF RC MODEL BOAT
,
Specifications : L1 = 17mm H =5mm L2= 28mm