BevRC
TAROT CARBON FIBER BATTERY BAY FOR FY680 AND X650
| Specifications | Carbon fiber |
: 20G,
four-axis , six-axis rack battery components , you can balance ...BevRC
TAROT 8-IN-1 HUB FOR OCTO
| Specifications | 24K |
BevRC
MASTOR-G BRUSHLESS GIMBALS FOR GOPRO(FREE SHIPPING IN EXPEDITED WAY)
| Free Download | firmware update.zip |
| Weight | 232g without camera |
| roll | 0.07 degrees; pitch |
| 12-hours angle drift | 0.12-1.5 degrees |
| Suitable payload | 120g-400g |
| Suitable flying wind Speed | < 38km/h |
Free Download:, Mastor-G quick start manual 2013-5-18.pdf, Free Download:, GoPro-G Assistant Software.zip, Leave us a note in your order such as:, 1: what lipo you plan to use, 3 cell or 4 cell lipo, 2: what camera you plan to use, gopro hero1/2 or hero3, All the gimbals shipped after 18th, May will be registered and with the sticker marked the SN number and register code, as below pic shows, pre adjusted with 3s lipo and naked gopro:, , ry please send email to:, support@bevrc.zendesk.com, Specs:, Based on STM32 32-bits high-speed MCU(tens of times faster than other open-source solutions), Size:, 10.7(12.5)*11*12cm, Roll angle limit:, > 360 degrees, Pitch angle limit:, >180 degrees, can be controlled by any p, : roll: 178 degrees/s; pitch: 182 degrees/s, Control accuracy:, Recommend camera:, gopro hero1,hero2, hero3, or similar cameras, Power:, 2-4 cell lipo, 3-cell recommend, can be powered as high as 6-cell(the high voltage input need to be reduce the power output parameters in the configuration tool.), COG adjustment range: X: 28mm Y:12mm Z:36mm,
We will pre-adjust it well for you to guarantee you ...BevRC
ZTW SPIDER 20A OPTO SIMONK FIRMWARE---- SPECIAL DESIGNED FOR MULTI-ROTOR
| Cont/Burst current | 20A/30A |
| Max power | 380w |
| Battery cell | 2-6 lipo |
| weight | 23g |
| BEC | NONE |
| Size | 25*43*9mm |
Feature:, Use new generation of the MOSFETs to make sure the ESC low heating and high reliability, Program: NO,
Spider series ESCs are especially designed to meeting the demand ...BevRC
BEVRC MOTOR- ELITE SERIES 4006 KV950
| Idle current@10v | 0.5A |
| Stator Diameter | 40mm |
| Stator Length | 23mm |
| Shaft diameter | 4mm |
| Motor diamension | 40*23mm |
| Weight | 75g |
| No. of Cells | 3-4s |
| Max continuous current | 20A |
| Max continuous power | 300w |
| Max efficiency | >82% |
| Internal resistance | 0.126ohms |
Spec:, KV: 950KV, Pop series: cost-effective, same or even cheaper price than 2212 and 2216 traditional motors, but with higher efficiency and heavier payload ability., Ellite series: same parametres with Pop series, but with better bearings and enamel insulated wires etc, which means longer life cycle.,
This is your best choice motors for 3s and 4s ...BevRC
BIG PREMOTION COMBO:DJI 2.4 GHZ BLUETOOTH DATALINK + IPAD GROUND STATIONG + WAYPOINT LICENSE
| 2.4G Bluetooth Datalink | ACE ONE, WKM, NAZA-M, NAZA-M V2; |
| iPAD Ground Station | WKM, NAZA-M, NAZA-M V2; |
| It currently supports the iOS devices (iOS 6.0.1 or above) with Bluetooth 4.0 (such as | iPad3, iPad4, iPad mini). |
| Customized joystick mode supported | The joystick control mode can be customized, and the default setting is Mode 2. |
| The Ground end | ≤2.3W |
| he Air end | ≤1.8W |
| The Ground end | 73mmx47.8mmx17.1mm |
| The Air end | 49.8mmx36.4mmx11.4mm |
| The Ground end | 93g |
| The Air end | 32g |
| The Ground end | 9.9V-25.2V |
2.4 GHz Bluetooth Datalink Functions:, 1. Provides communications between the Ground end and the Air end using the DJI bidirectional data communication modules; the iPAD Ground Station communicates with the Ground end using the BTU module;, Note:, , Technical Specifications:, FCC Version(USA), The Air end: 6V,
2. Use the 2.4G Bluetooth Datalink Assistant Software to upgrade ...BevRC
BIG PREMOTION COMBO:DJI NAZA V2 GPS/ ZENMUSE H3-2D COMBO [DJI-NMH32D]
,
Don't miss out on this limited time opportunity! Buy a ...BevRC
TMF HAWKEYE BP-1 BRUSHLESS GIMBAL FOR GOPRO HERO1/HERO2
Your purchase includes:, 1* BP-1 gimbal with controller and video cable of hero1/hero2,
The world lightest brushless gimbal with controller built-in, 150g only. ...BevRC
SELF-TIGHTENING NUTS FOR MULTI-COPTER MOTORS AND PROPS CW/CWW PAIR
| https | //www.youtube.com/watch?v=HzJvHF9ppb0&list=HL1378270352&feature=mh_lolz |
Check the video below for details:, Your purchase includes:, 1* CW nut,
Creative design, precise CNC machined, compatible with nearly all the ...BevRC
DJI PHANTOM 2 PROPS PAIR WITH AUTO-TIGHTENING NUT
Your purchase includes:, 1 * CW 9433 prop,
Upgrade the prop for your phantom 1 to get 3 ...