RCModelScout.

RCTimer

433Mhz ArduFlyer UAV GPS Flight Control System

Features:, Arduino and ArduPilot Mega 2.5 Compatible!, It's designed as an open source Xbee replacement radio set, offering a lower price, longer range (approx one mile) and superior performance to Xbee radios. It’s available in 915Mhz ; and in the following configurations:, serial board (for the air) and USB (for the ground)., GPS CN06 Features:, ,

433Mhz ArduFlyer UAV GPS Flight Control System

Deal of Day!

The ArduFlyer is a complete open source autopilot system. Its design come from 3DRobotics and it 100% compatible with APM2.5. It allows the user to turn any fixed, rotary wing or multirotor vehicle (even cars and boats) into a fully autonomous vehicle; capable of performing programmed GPS missions with waypoints. This version comes with the RC/Servo connectors unsoldered, so you can choose between straight or right-angled ones, both of which are included.

Includes both right angle and straight pins for I/O, allowing user to customize as needed.

Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer

Onboard 16Mbit Dataflash chip for automatic datalogging

Digital compass powered by HMC
5883L
chip, included on the main board.

Invensense's 6 DoF Accelerometer/Gyro MPU-6000.

Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties.

Atmel's ATMEGA2560-16AU and ATMEGA32U-2 chips for processing and usb functions respectively.

The RCTimer Radio telemetry system base on 3DR Radio system and 100% compatible.

The system provides a full-duplex link

using HopeRF's HM-TRP modules running custom, open source firmware.

Interface to the module is via standard 5V-tolerant TTL serial / FTDI USB serial.

Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through the 3DR Radio configurator and AT commands.

·
Standalone GPS receiver

·
u-blox NEO
-6M
GPS module

·
EEPROM for save configuration permanently

·
Build in 25X
25mm
active antenna

·
UART (TTL) port with EMI protection

·
Rechargeable battery for backup/hotstart

Default parameter

·

If this GPS receiver used for I
2C
-GPS NAV Board, it must be changed to baud rate 115200 / update rate 5hz.

Package content

·
Apm2.5 x 1

·
CN06 V2.0 x 1

·
RCTimer Radio Telemetry Kit 433Mhz x 1

Found 11 years, 9 months ago