AIOP-UAV 433Mhz Autopilot GPS Flight Control System

Discountinued

RCTimer

AIOP-UAV 433Mhz Autopilot GPS Flight Control System

Baud rate	9600

Hardware Features:, •Supported MegaPirateNG /ArduCopterNG/ArduPlaneNG/MultiWii/AeroQuad firmware, It's designed as an open source Xbee replacement radio set, offering a lower price, longer range (approx one mile) and superior performance to Xbee radios. It’s available in 915Mhz ; and in the following configurations:, serial board (for the air) and USB (for the ground)., GPS CN06 Features:, ,

AIOP V2.0 UAV 433Mhz Autopilot GPS Flight Control System

Deal of Day!

•8-axis motor output
•8 input channels for standard receiver and PPM SUM input channel
•3 servos output for gimbal system
•4 serial ports for debug/Bluetooth/OSD/GPS/telemetry module
•8 Analog port for Airspeed Sensor/Current & Voltage Sensor/LED controller
•D32~37 & PG1~PG5 pads
•I2C 5V port for external device
•
Onboard 16Mbit Dataflash chip for automatic datalogging
•ATMega 2560-16AU Microcontroller
•MPU6050 6 axis gyro/accel with Motion Processing Unit
•HMC5883L 3-axis digital magnetometer
•MS5611-01BA03 highprecision altimeter
•FT232RQ USB-UART chip and Micro USB receptacle
•On board logic level converter
•Match the standard of RoHS

Input power selection
•One of the following way
- Connect 5V power cable from ESC or UBEC to the ESC/Servo port, the J1 jumper must be closed.
- Connect 5V power cable to the external power port, the J1 jumper must be removed.

The RCTimer Radio telemetry system base on 3DR Radio system and 100% compatible.

The system provides a full-duplex link

using HopeRF's HM-TRP modules running custom, open source firmware.

Interface to the module is via standard 5V-tolerant TTL serial / FTDI USB serial.

Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through the 3DR Radio configurator and AT commands.

·
Standalone GPS receiver

·
u-blox NEO
-6M
GPS module

·
EEPROM for save configuration permanently

·
Build in 25X
25mm
active antenna

·
UART (TTL) port with EMI protection

·
Rechargeable battery for backup/hotstart

Default parameter

If this GPS receiver used for I
2C
-GPS NAV Board, it must be changed to baud rate 115200 / update rate 5hz.

Package content

·
AIO PRO FC V2.0 x 1

·
CN06 V2.0 x 1

·
RCTimer Radio Telemetry Kit 433Mhz x 1