RCModelScout.

DPCAV

RG-174/U 50 OHM MINIATURE COAX

DPCAV

GUARDIAN 2D/3D INERTIAL STABILIZER (STANDALONE MODEL)

Q: Why do I need the Guardian?, The Guardian helps both beginner and expert pilots fly with confidence, and provides two key modes of operation: In 2D flight mode, the Guardian provides much smoother flight and wing leveling stabilization for your model, which makes it a lot easier to adjust and fly your plane. The Guardian "remembers" level flight for your model and returns it to level flight when needed, as well as providing precise "fly by wire" control., The Guardian has two submodes for 3D flying: In 3D Heading Lock submode, simply center your sticks to have the Guardian lock onto your present attitude (pitch, roll, and heading), which can make it easier to perform stunts like prop hanging, inverted flight, knife edges, low speed harriers, etc. In 3D Gyro submode, the Guardian uses its built-in 3 axis gyro to increase your model’s stability, while leaving you in full control. In this mode the Guardian greatly reduces the effects of gusts, turbulence, motor torque and other factors, and can expand the maneuverability of your model in a variety of conditions., Q: I Fly FPV. Is the Guardian for me?, Q: Will the Guardian work with my model?, Q: How do I install the Guardian?, Q: How do I configure the Guardian?, Q: How does the Guardian work?, Q: What sets the Guardian apart from other Stabilization systems out there?, *Note: Using the PC software will require a common Micro-USB cable. Most likely you already have one of these, but it not then they are available from your local electronic/computer store.,

DPCAV

5-PIN PCB CONNECTOR FOR LS20033 GPS

DPCAV

REPLACEMENT EM-406A & EM-411 GPS CABLE

,

DPCAV

REPLACEMENT FV-M8 & EB-85A GPS CABLE, 4 INCH

Important Note: This is the factory stock cable for generic installations. If you need the special FV-M8 or EB-85A 5-Hz micro GPS cable that is used with the Inspire OSD, then please order the,

DPCAV

ELOGGER GPS-V4 EXPANDER MODULE (10-HZ)

Note: When using the GPS Expander on your eLogger with 30VDC or higher voltages, the optional Battery Backup Cable, Update: We are now shipping the latest version with integrated EMI/RFI Toroid filter and longer cable. The filter reduces GPS signal interference problems caused by some wireless video transmitters. Please see photo on the right., GPS Expander Specifications:,

DPCAV

SMA STRAIGHT BULKHEAD JACK, CRIMP

SMA Straight bulkhead jack (receptacle), crimp type. For use with RG-174, RG-179, RG-188, and RG-316 series coax. The connector has three components: the SMA jack, a solder-on center pin, and a crimp ferrule. Includes nut and washer for optional bulkhead mounting,

DPCAV

SMA STRAIGHT PLUG, CRIMP (2-PIECE DESIGN)

,

DPCAV

SMA RF TERMINATOR, 50 OHMS / 1 WATT

Specifications:, ,

DPCAV

SMA RF TERMINATOR, 50 OHMS / 2 WATT

Specifications:, ,

DPCAV

SMA T-ADAPTER

DPCAV

SMA RIGHT ANGLE ADAPTER

IMPORTANT: This is a standard SMA connector. If you need a "reverse polarity" RP-SMA right angle connector then please see item,

DPCAV

SMA STRAIGHT PLUG TO PLUG ADAPTER

DPCAV

SMA CONNECTOR, RIGHT ANGLE PLUG, PCB

DPCAV

SMA EDGE LAUNCH PCB JACK RECEPTACLE